Answer:
<h2>
15m/s</h2>
Explanation:
The equation for a traveling wave as expressed as y(x, t) = A cos(kx − 
t) where An is the amplitude f oscillation, is the angular velocity and x is the horizontal displacement and y is the vertical displacement.
From the formula; 
where;
Before we can get the transverse speed, we need to get the frequency and the wavelength.
frequency = 1/period
Given period = 2/15 s
Frequency = 
frequency = 1 * 15/2
frequency f = 15/2 Hertz
Given wavelength 
= 2m
Transverse speed 
Hence, the transverse speed at that point is 15m/s
Strength of induced current increased when strength of magnetic field increases. It will also increase when the number of turns are increased or if the speed of conductor increases
Answer:
The block didn't slide due to balancing of gravitational force with friction force
Explanation:
When the block was given a flick the force provided an acceleration to it and it moved up the inclined plane. when the block reached top it was expected that it would slide back but it didn't this happened because of the frictional force acting on the bottom the block which was balancing the gravitational force component along the plane and this prevented sliding back of the block.
static friction was balancing mg*sin(theta)
fs = mg*sin(theta)
This question sounds like it came after some activity where
some forces were observed. Since we were not there, and
we don't know what the activity was, we don't know what forces
were observed, and we have no clue to how they might be related
to the motion of the Earth around the sun.
Answer:
The ball has an initial linear kinetic energy and initial rotational kinetic energy which can both be converted into gravitational potential energy. Therefore the hill with friction will let the ball reach higher.
Explanation:
The ball has an initial linear kinetic energy and initial rotational kinetic energy which can both be converted into gravitational potential energy. Therefore the hill with friction will let the ball reach higher.
This is because:
If we consider the ball initially at rest on a frictionless surface and a force is exerted through the centre of mass of the ball, it will slide across the surface with no rotation, and thus, there will only be translational motion.
Now, if there is friction and force is again applied to the stationary ball, the frictional force will act in the opposite direction to the force but at the edge of the ball that rests on the ground. This friction generates a torque on the ball which starts the rotation.
Therefore, static friction is infact necessary for a ball to begin rolling.
Now, from the top of the ball, it will move at a speed 2v, while the centre of mass of the ball will move at a speed v and lastly, the bottom edge of the ball will instantaneously be at rest. So as the edge touching the ground is stationary, it experiences no friction.
So friction is necessary for a ball to start rolling but once the rolling condition has been met the ball experiences no friction.
