Just look it up on google kodvjkngkrefsnjkvjfrnefsjkj
<span>Chemically speaking, rust is a base and any acid will remove it. The choice of acid is going to be the thing to consider, since acid + base = salt and water. Phosphoric acid left a residue because the salt Iron phosphate is insoluble in water. Iron's soluble salts include the chloride, the sulfate and the nitrate. Industrially speaking, you need to "pickle" your iron. Pickling is a process in which dilute sulfuric acid is used to remove any surface corrosion prior to either painting or plating an iron surface. Sulfuric acid is ordinary battery acid and the salt Iron sulfate is not toxic. Sulfuric acid is one of the most common acids used (besides hydrochloric acid). The dilute kind is not terribly corrosive but concentrated sulfuric acid is a thick, syrupy liquid which can cause some nasty chemical burns if allowed to remain on the skin. It also heats up quite a lot when water is added, so this is an "Acid to water not water to acid" situation. The other choice is Hydrochloric acid, known as muriatic acid. The 20% concentrate is available in nearly any hardware store. It isn't as corrosive as concentrated sulfuric acid, but it has a burning, acrid stench, so never use the concentrate without adequate ventilation. It is ordinarily used to remove hard water deposits (boiler scale) but does a good on on rust as well. Concentrated Iron chloride isn't entirely inert but lots of rinsing will turn it back into harmless rust/sludge, especially if the rince water is naturally hard. Nitric acid will remove corrosion from anything, but it is extremely corrosive, smells worse then Hydrochloric acid and isn't easy to get, since it can be used to create some powerful explosives</span>
Answer:
Please find the answer to the question below
Explanation:
In chemistry, the following mathematical formula is used to calculate the number of moles contained by a substance:
mole = mass of substance (g)/molar mass of substance (g/mol)
Molar mass of salicylic acid (C7H6O3) = 12(7) + 1(6) + 16(3)
= 84 + 6 + 48
= 138g/mol
Mass = 5.50grams
mole = 5.5/138
mole = 0.039
Approximately, the number of moles of 5.5grams of salicylic acid is 0.04moles. This is in accordance with the mole value (0.04) given in this question.
Answer:
The molar mass of the unknown gas is 
Explanation:
Let assume that the gas is O2 gas
O2 gas is to effuse through a porous barrier in time t₁ = 4.98 minutes.
Under the same conditions;
the same number of moles of an unknown gas requires time t₂ = 6.34 minutes to effuse through the same barrier.
From Graham's Law of Diffusion;
Graham's Law of Diffusion states that, at a constant temperature and pressure; the rate of diffusion of a gas is inversely proportional to the square root of its density.
i.e
where K = constant
If we compare the rate o diffusion of two gases;
Since the density of a gas d is proportional to its relative molecular mass M. Then;
Rate is the reciprocal of time ; i.e
Thus; replacing the value of R into the above previous equation;we have:
We can equally say:
The textbook would lose potential energy since its falling from a high height.
