Answer:
The governing ratio for thin walled cylinders is 10 if you use the radius. So if you divide the cylinder´s radius by its thickness and your result is more than 10, then you can use the thin walled cylinder stress formulas, in other words:
- if then you have a thin walled cylinder
or using the diameter:
- if then you have a thin walled cylinder
Answer:
The method will be explained below
Explanation:
The APWA methodology will be used to compute the calculation.
Answer:
hello your question is incomplete attached below is the missing part of the question
Consider an inverter operating a power supply voltage VDD. Assume that matched condition for this inverter. Make the necessary assumptions to get to an answer for the following questions.
answer : Nd ∝ rt
Explanation:
Determine how the delay and active power per device will change as the doping density of N- and P-MOSFET increases
Pactive ( active power ) = Efs * F
Pactive =
also note that ; Pactive ∝ Nd2 (
tD = K . since K = constant
Hence : Nd ∝ rt
The reactor, generator, and the cooling towers
Answer:
A. R
Explanation:
There are basically two wires that supply input power to the thermostat namely the C wire which is the common wire and the R wire .The G wire simply completes the input power circuit from the R-leg of the power supply.On the another hand the Y wire also completes the circuit from the compressor fan contactor to the R-leg of the power supply . While the W wire completes the path to the heater contactor coil.