It takes 56.5 kilojoules of energy to raise the temperature of 150 milliliters of water from 5°C to 95°C. If you
1 answer:
You might be interested in
Answer:
Impulse of force = -80 Ns
Explanation:
<u>Given the following data;</u>
Mass = 50kg
Initial velocity = 1.6m/s
Since she glides to a stop, her final velocity equals to zero (0).
Now, we would find the change in velocity.
Substituting into the equation above;
Change in velocity = 0 - 1.6 = 1.6m/s
Substituting into the equation, we have;
<em>Impulse of force = -80 Ns</em>
<em>Therefore, the impulse of the force that stops her is -80 Newton-seconds and it has a negative value because it is working in an opposite direction, thus, bringing her to a stop. </em>
Answer:
A) the ammeter is x
B)
- voltage across R₁ (left resistor) = 0.75 V
- voltage across the right one = 0.3 V
C) 1.05 V
Explanation:
From the diagram attached below;
A) Assuming the homes were wired in series, and one of the homes face short circuit then all the houses would face power cut but it doesn't happen. So they must be connected in parallel.
Therefore; The ammeter is connected in series, Hence, the ammeter is x and the voltmeter must be z.
B)
Given that:
x = 0.15 A
z = 0.3 V
Resistor (R) on the left = 5 ohms
Then, voltage across R₁ (left resistor) = 5×(x)
= 5×0.15
= 0.75 V
voltage across the right one = z = 0.3 V
C)
The total voltage of battery = 0.75+0.3 = 1.05 V
Answer:
6.0 × W/
Explanation:
From Wien's displacement formula;
Q = e A
Where: Q is the quantity of heat transferred, e is the emissivity of the surface, A is the area, and T is the temperature.
The emissive intensity = = e
Given from the question that: e = 0.6 and T = 1000K, thus;
emissive intensity = 0.6 ×
= 0.6 × 1.0 ×
= 6.0 ×
Therefore, the emissive intensity coming out of the surface is 6.0 × W/
.