I believe it’s c because you don’t want your gas to run real low, so I think it’s best to do it when your fuel.
90% of traffic crashes are due to driver error.
True
Answer:
a) Tբ = 151.8°C
b) ΔV = - 0.194 m³
c) The T-V diagram is sketched in the image attached.
Explanation:
Using steam tables,
At the given pressure of 0.5 MPa, the saturation temperature is the final temperature.
Right from the steam tables (A-5) with a little interpolation, Tբ = 151.793°C
b) The volume change
Using data from A-5 and A-6 of the steam tables,
The volume change will be calculated from the mass (0.58 kg), the initial specific volume (αᵢ) and the final specific volume
(αբ) (which is calculated from the final quality and the consituents of the specific volumes).
ΔV = m(αբ - αᵢ)
αբ = αₗ + q(αₗᵥ) = αₗ + q (αᵥ - αₗ)
q = 0.5, αₗ = 0.00109 m³/kg, αᵥ = 0.3748 m³/kg
αբ = 0.00109 + 0.5(0.3748 - 0.00109)
αբ = 0.187945 m³/kg
αᵢ = 0.5226 m³/kg
ΔV = 0.58 (0.187945 - 0.5226) = - 0.194 m³
c) The T-V diagram is sketched in the image attached
Answer:
51.4 Ohms
Explanation:
By applying voltage division rule
where v is voltage, subscripts i and f represnt initial and final, R is resistance, m is internal and l is external.Substituting 7V for final voltage, 10V for initial voltage and the external resistance as 120 Ohms then
The correct statement is: a higher than a normal voltage drop could indicate high resistance. Technician B is correct.
<h3>Ohm's law</h3>
Ohm's law states that the current flowing through a metallic conductor is directly proportional to the voltage provided all physical conditions are constant. Mathematically, it is expressed as
V = IR
Where
V is the potential difference
I is the current
R is the resistance
<h3>Technician A</h3>
High resistance causes an increase in current flow
V = IR
Divide both side by I
R = V / I
Thus, technician A is wrong as high resistance suggest low current flow
<h3>Technician B</h3>
Higher than normal voltage drop could indicate high resistance
V = IR
Thus, technician B is correct as high voltage indicates high resistance
<h3>Conclusion </h3>
From the above illustration, we can see that technician B is correct
Learn more about Ohm's law:
brainly.com/question/796939
