Write any s uses of heat energy and Suses of light<br>energy.

Below is a circuit schematic of sources and resistors (Figure 3). VS = 10V , R1 = 100Ω, R2 = 50Ω, R3 = 25Ω, IS = 2A. Calculate t

lorasvet [3.4K]

Answer:

$V_3\approx 4.28\,\,V$

$I_1=0.0572\,\,amps$

$I_3\approx 0.171\,\,amps$

Explanation:

Notice that this is a circuit with resistors R1 and R2 in parallel, connected to resistor R3 in series. It is what is called a parallel-series combination.

So we first find the equivalent resistance for the two resistors in parallel:

$\frac{1}{Re}= \frac{1}{R1}+\frac{1}{R2}\\\frac{1}{Re}= \frac{1}{100}+\frac{1}{50}\\\frac{1}{Re}= \frac{3}{100}\\Re=\frac{100}{3} \,\,\Omega$

By knowing this, we can estimate the total current through the circuit,:

$Vs=I\,*\,(\frac{100}{3} +25)\\10=I\,*\,\frac{175}{3} \\I=\frac{30}{175} \,amps$

So approximately 0.17 amps

and therefore, we can estimate the voltage drop (V3) in R3 uisng Ohm's law:

$V_3=\frac{30}{175} *\,25=\frac{30}{7} \approx 4.28\,\,V$

So now we know that the potential drop across the parellel resistors must be:

10 V - 4.28 V = 5.72 V

and with this info, we can calculate the current through R1 using Ohm's Law:

$I_1=\frac{V_1}{R_1} =\frac{5.72}{100} =0.0572\,\,amps$

4 0

3 years ago

From left to right across a period in the periodic table, elements become less ___________ and more ______________ in their prop

leonid [27]

***elements become less electropositive and more electronegative in their properties...

7 0

3 years ago

Read 2 more answers

Scientists in a test lab are testing the hardness of a surface before constructing a building. Calculations indicate that the en

Over [174]

It depends on what that "certain amount" is.

7 0

3 years ago

Pressure is about 1000 hPa at sea level and about 500 hPa at an altitude of 5.5 km. Why doesn’t this vertical pressure gradient

saul85 [17]

Answer:

A. The upward pressure gradient force is balanced by gravity.

Explanation:

A. is correct because the pressure difference is actually generated by gravity. As in the following formula for the pressure at different points:

$p = p_0 + \rho g h$

where $p, p_0$ are the pressure at 2 points, ρ is the density of the fluid, g is the gravitational constant, and h is the height difference.

B is incorrect because friction in air is too small to make an effect.

C is incorrect because the Coriolis force is horizontal, not vertical.

D is incorrect because a difference of 500 hPa = 50000 Pa, this is half of the atmospheric pressure.

E is incorrect because temperature cannot generate force.

6 0

3 years ago

IM A plastic sphere floats in water with 50.0% of its volume submerged. This same sphere floats in glycerin with 40.0 \% of its

arsen [322]

Density of glycerin is 5/4 times water density.

Density of the sphere is 1/2 times water density.

<h3>How to find the density of sphere floats and glycerin?</h3>

Density is defined as the ratio of mass to volume, that is density is the amount of mass per unit of volume.

A substance's density exist defined as its mass per unit of volume. Density is most frequently represented by the symbol, however Latin letter D may also be utilized. If the mass or volume of an object is altered, the density of the thing may also change. Water, for example, has a specific density. An object will sink if its density exists greater than that of water; it will float if its density is lower.

Since a plastic sphere floats in water with 50% of its volume submerged.

So, the Density of the sphere = 1/2× water density

Since the same sphere floats in glycerin with 40% of its volume submerged.

So, the Density of the sphere = 4/100 × Glycerin density

= 2/5 × Glycerin density

Density of Glycerin = 5/2 of sphere density

Density of glycerin = 5/2 × 1/2 × water density

Density of glycerin = 5/4 × water density

To learn more about the volume of sphere floats refer to:

brainly.com/question/10827296

#SPJ4

6 0

1 year ago

Write any s uses of heat energy and Suses of lightenergy.​

Write any s uses of heat energy and Suses of lightenergy.