Scientists use models for many reasons. What is one of those reasons?
2 answers:
You might be interested in
0.02020 ohm is the resistance of a carbon rod at 25.8 ∘C if its resistance is 0.0200 Ω at 0.0 ∘C.
<h3 /><h3>What is a resistor?</h3>A resistor is an electrical component that controls or restricts how much electrical current can pass across a circuit in an electronic device. A specified voltage can be supplied via resistors to an active device like a transistor.
The temperature of the resistor varies based on the variation in the temperature. The equation that describes the relationship between the two of them is:
R = R0[1+ alpha(T-T0)] where:
R is the new resistance we are looking for
alpha is the temperature coefficient of resistance. For carbon rod, alpha = ₋ 4.8 x (1/°c)
T0 is the standard temperature =25.8°C
R0 is the resistance at T0 = 0.0200 ohms
T is the temperature at which we want to get R = 0
Substitute in the equation to get R as follows:
R = 0.0200 [1+( ₋ 4.8 x ) (0-25.8)] = 0.02020 ohm
To know more about resistance refer to: brainly.com/question/11431009
#SPJ1
You have not provided the diagram, therefore, I cannot provide an exact answer.
However, I will try to help by explaining how to solve this problem.
When light moves from air to glass:
1- part of the light is reflected back into the air where the angle of incidence is equal to the angle of reflection
2- part of the light enters the water and refracts. The angle of refraction can be calculated using Snell's law.
In a diagram, the reflected ray would be the one getting back into air while the refracted ray would be the one entering the water.
You can check the attached diagram for further illustrations.
Hope this helps :)
However, I will try to help by explaining how to solve this problem.
When light moves from air to glass:
1- part of the light is reflected back into the air where the angle of incidence is equal to the angle of reflection
2- part of the light enters the water and refracts. The angle of refraction can be calculated using Snell's law.
In a diagram, the reflected ray would be the one getting back into air while the refracted ray would be the one entering the water.
You can check the attached diagram for further illustrations.
Hope this helps :)