Coulomb's Law says that the forces between any two charges depends __________

When a cold air mass and a warm air mass meet but are at a standstill, the boundary is called.

Sphinxa [80]

Answer:

Ur answer is Stationary Front

Explanation:

Stationary Front is when a cold air mass and a warm air mass but are at a standstill the boundary is called Stationary Front.

3 0

2 years ago

A proton moving at 3.0 × 10^4 m/s is projected at an angle of 30° above a horizontal plane. If an electric field of 400 N/C is a

GuDViN [60]

Answer:

The time it takes the proton to return to the horizontal plane is 7.83 X10⁻⁷ s

Explanation:

From Newton's second law, F = mg and also from coulomb's law F= Eq

Dividing both equations by mass;

F/m = Eq/m = mg/m, then

g = Eq/m --------equation 1

Again, in a projectile motion, the time of flight (T) is given as

T = (2usinθ/g) ---------equation 2

Substitute in the value of g into equation 2

$T = \frac{2usin \theta}{\frac{Eq}{m}} =\frac{m* 2usin \theta}{Eq}$

Charge of proton = 1.6 X 10⁻¹⁹ C

Mass of proton = 1.67 X 10⁻²⁷ kg

E is given as 400 N/C, u = 3.0 × 10⁴ m/s and θ = 30°

Solving for T;

$T = \frac{(1.67X10^{-27}* 2*3X10^4sin 30}{400*1.6X10^{-19}}$

T = 7.83 X10⁻⁷ s

6 0

3 years ago

If stellar parallax can be measured to a precision of about 0.01 arcsec using telescopes on the Earth to observe stars, to what

marin [14]

Answer:

It corresponds to a distance of 100 parsecs away from Earth.

Explanation:

The angle due to the change in position of a nearby object against the background stars it is known as parallax.

It is defined in a analytic way as it follows:

$\tan{p} = \frac{1AU}{d}$

Where d is the distance to the star.

$p('') = \frac{1}{d}$ (1)

Equation (1) can be rewritten in terms of d:

$d(pc) = \frac{1}{p('')}$ (2)

Equation (2) represents the distance in a unit known as parsec (pc).

The parallax angle can be used to find out the distance by means of triangulation. Making a triangle between the nearby star, the Sun and the Earth (as is shown in the image below), knowing that the distance between the Earth and the Sun (150000000 Km), is defined as 1 astronomical unit (1AU).

For the case of ( $p('') = 0.01$ ):

$d(pc) = \frac{1}{0.01}$

$d(pc) = 100$

Hence, it corresponds to a distance of 100 parsecs away from Earth.

<em>Summary:</em>

Notice how a small parallax angle means that the object is farther away.

Key terms:

Parsec: Parallax of arc second

7 0

3 years ago

The increase of kinetic energy at the square of the speed of your vehicle has a major influence on all motor vehicles in three p

Viktor [21]

This implies that stopping distance and impact force grow as a function of speed. The best ways to improve manoeuvrability and lessen crash severity are to drive at an appropriate pace and to slow down as soon as you spot dangers in front of you.

Keep in mind that stopping distance increases with speed; at 50 mph, it is four times longer than at 25 mph, and at 75 mph, the force of impact is nine times greater.

<h3>What is the impact of speed on kinetic energy ?</h3>

When your car expends or absorbs energy to speed up or slow down, you may feel a pull or a jolt, called impulse. Impulse increases as the energy or force increases, and increases as the duration of the force decreases. You'll feel a harder jolt if you speed up or slow down suddenly.

Consider: coming to a stop from 60 mph in ten seconds doesn't hurt you or your vehicle because the force of this event is spread out over a long time. But if you hit a wall and come to a stop in just half a second, you'll feel twenty times the impulse, causing severe damage.

Learn more about Kinetic energy here:

brainly.com/question/25959744

#SPJ4

5 0

2 years ago

In a certain time period a coil of wire is rotated from one orientation to another with respect to a uniform 0.38-T magnetic fie

juin [17]

<h2>The emf produced is 7.2 V</h2>

Explanation:

When coil is placed in the magnetic field , the flux attached with it can be found by the relation . Flux Ф = the dot product of magnetic field and area of coil .

Thus Ф = B A cosθ

here B is magnetic field strength and A is the area of coil .

The angle θ is the angle between coil and field direction .

When coil rotates , the angle varies . By which the flux varies . The emf is produced in coil due to variation of flux . The relation for this is

The emf produced ξ = - $\frac{d\phi}{dt}$ = B A sinθ $\frac{d\theta}{dt}$