Answer:
Not between significant digits.
Explanation:
A zero not significant when it's not between significant digits.
Answer:
27J
Explanation:
From conservation of Thermal energy, the total internal energy is the total sum of energy supplied or taken from the system plus work done for or on the system.
Now the change in internal energy would be the sum of the received energy substended in the gas plus the work done by the system which is workdone that it will sustend in pushing the lid. This is expressed mathematically as;
U = Q + (F×d);
U- change in internal energy
Q is the energy received by the system and is positive when energy is received by the system.
Fxd is the workdone and is positive since the gas pushes up the lid- the system does work.
U=12+(3×5)= 27J
<u>Answer
</u>
A. 1 and 2
<u>Explanation
</u>
At point 1 we have the highest potential energy and the kinetic energy is zero.
At 2 the potential energy is minimum and the kinetic energy is maximum.
The law of conservation of energy says that energy cannot be created nor destroyed. So, the change in P.E = Change in K.E.
P.E = height × gravity × mass. The height referred here is the perpendicular height. Gravity and mass are constant in this case.
From the diagram it can be seen clearly that the vertical height from 2 to 1 is much greater than from 4 to 3.
This shows that the change in P.E is greater between 1 and 2 and so is kinetic energy.
When two black holes spiral around each other and ultimately collide, they send out gravitational waves - ripples in space and time that can be detected with extremely sensitive instruments on Earth. ... If confirmed, it would be the first known light flare from a pair of colliding black holes.
Answer:
Amplitude = 8 Volts
Frequency = 0.067 kHz
Explanation:
Note: The missing picture in question is attached for your review.
Given:
Volts/Div = 2 V/div
Time/Div = 5 msec/div
Finding Amplitude:
Now, as you can see in the attached picture, there are 4 division between two peaks of the waveform, so,
(Multiplying by 2 V/div because oscilloscope dial is set at 2 V/div)
Finding Frequency:
As can be seen in attached picture, 3 division are there for one complete cycle of waveform,so,
Since,
