1answer.
Ask question
Login Signup
Ask question
All categories
  • English
  • Mathematics
  • Social Studies
  • Business
  • History
  • Health
  • Geography
  • Biology
  • Physics
  • Chemistry
  • Computers and Technology
  • Arts
  • World Languages
  • Spanish
  • French
  • German
  • Advanced Placement (AP)
  • SAT
  • Medicine
  • Law
  • Engineering
crimeas [40]
3 years ago
14

Importance of SI system in points​

Physics
1 answer:
monitta3 years ago
4 0

Answer:

SI unit is an international system of measurements that are used universally in technical and scientific research to avoid the confusion with the units. Having a standard unit system is important because it helps the entire world to understand the measurements in one set of unit system.

You might be interested in
I need help plz and thank you this is due
xeze [42]

Answer:

Grow up man, this is completely based on your curriculum, we would need your book to answer, and this has to be done by you.

3 0
3 years ago
Read 2 more answers
Which one of the following is a derived Si unit a. Newton, b. Meter, c. Mole, d. Kiogram<br>​
Sever21 [200]

I think newton is the answer

4 0
3 years ago
Read 2 more answers
★CHECK MY ANSWER PLEASE★
Sergeu [11.5K]
You are correct!
Happy to assist you!
8 0
3 years ago
Read 2 more answers
A baseball has mass 0.147 kg. If the velocity of a pitched ball has a magnitude of 44.5 m/s and the batted ball's velocity is 55
Anit [1.1K]

Explanation:

We have,

Mass of a baseball is 0.147 kg

Initial velocity of the baseball is 44.5 m/s

The ball is moved in the opposite direction with a velocity of 55.5 m/s

It is required to find the magnitude of the change in momentum of the ball and of the impulse applied to it by the bat.

Change in momentum,

\Delta p=mv-mu\\\\\Delta p=m(v-u)\\\\\Delta p=0.147\times ((-55.5)-44.5)\\\\\Delta p=-14.7\ kg-m/s\\\\|\Delta p|=14.7\ kg-m/s

Impulse = 14.7 kg-m/s

Therefore, the magnitude of the change in momentum of the ball and of the impulse applied to it by the bat is 14.7 kg-m/s

4 0
3 years ago
A copper wire 1.0 meter long and with a mass of .0014 kilograms per meter vibrates in two segments when under a tension of 27 Ne
Furkat [3]

Answer:

the frequency of this mode of vibration is 138.87 Hz

Explanation:

Given;

length of the copper wire, L = 1 m

mass per unit length of the copper wire, μ = 0.0014 kg/m

tension on the wire, T = 27 N

number of segments, n = 2

The frequency of this mode of vibration is calculated as;

F_n = \frac{n}{2L} \sqrt{\frac{T}{\mu} } \\\\F_2 = \frac{2}{2\times 1} \sqrt{\frac{27}{0.0014} }\\\\F_2 = 138.87 \ Hz

Therefore, the frequency of this mode of vibration is 138.87 Hz

7 0
3 years ago
Other questions:
  • How do u convert 7.68 cal/sec to kcal/min
    13·2 answers
  • It is too cold<br>for liquid<br>water to exist<br>on the<br>surface.​
    6·1 answer
  • A toboggan and rider have a total mass of 100 kg and travel down along the (smooth) slope defined by the equation y=0.2x2. At th
    14·1 answer
  • A 2.85 kg fish is attached to the lower end of a vertical spring that has negligible mass and force constant 875 N/m. The spring
    13·1 answer
  • Which state Which states of matter have a set volume? Explain why this is, based on the animations you observed for the differen
    9·1 answer
  • At what temperature (degrees Fahrenheit) is the Fahrenheit scale reading equal to (a) 2 times that of the Celsius and (b) 1/4 ti
    5·1 answer
  • The tub of a washer goes into its spin-dry cycle, starting from rest and reaching an angular speed of 4.0 rev/s in 9.0 s. At thi
    14·1 answer
  • Direction of wind: from to​
    6·1 answer
  • A car of mass M traveling with velocity v strikes a car of mass M that is at rest. The two cars’ bodies mesh in the collision. T
    12·1 answer
  • Find the current passing through each of the 3 resistors connected parallel to each other as shown in the figure (i1, i2, I3). S
    6·1 answer
Add answer
Login
Not registered? Fast signup
Signup
Login Signup
Ask question!