Answer:
When hydrogen is passed over hot ferric oxide (FeO) hydrogen reacts with oxygen present in the compound and forms water (H2O) and pure Iron
Explanation:
Answer:
The other colors of the electromagnetic spectrum are absorbed by the substance and not reflected. If you were to look at it in infared or unltraviolet it would reflect different colors than those of the visible spectrum.
Explanation:
Answer:
A solution in which no more solute can be dissolved in is referred to as SATURATED. In such a solution, the concentration of solute is called SOLUBILITY . When that concentration is reported in moles per liter, it is more specifically called MOLAR SOLUBILITY. A special equilibrium constant called the SOLUBILITY PRODUCT constant is calculated from the molar concentrations of the aqueous components of the dissolution equation.
Explanation:
The solubility of a solute in a solvent is the maximum amount of solute in moles that will be dissolved in 1dm3 of the solvent at a specified temperature. Once the maximum number or concentration has been reached, the solvent can no longer take in solutes and this point in the reaction, the solution is said to be saturated. That is the composition of the saturated solution is not affected by the presence of excess solute. An unsaturated solution has a lower concentration of solute and can dissolve more solutes if added until it becomes saturated.
Solubility when reported in moles per liter is called molar solubility of the solution and it gives a more accurate measurement of yh solubility of a solution. The solubility product constant is calculated from the molar concentrations of the aqueous components of the dissolution equation. This solubility product constant explains the balance between dissolved ions from the salt and undissolved salt in a dissolution equation.
0.003 moles of NaOH was used in the titration.
<h3>What is titration?</h3>
The concentration of an identified analyte can be found using a simple laboratory technique called titration. As a standard solution with a given concentration and volume, a reagent known as the titrant or titrator is created.
By using a solution with a known concentration to measure the concentration of an unknown solution, this process is known as titration. To a known volume of the analyte (the unknown solution), the titrant (the known solution) is typically added from a buret until the reaction is finished. To ascertain the unknown concentration of an identifiable analyte, titration, commonly referred to as titrimetry, is a widely used quantitative laboratory analytical technique (Medwick and Kirschner, 2010). Volume measurements are a crucial component of titration
Concentration in mol/dm3 =
Amount of solution mol
= concentration in mol/dm3 × volume in dm3
Amount of sodium hydroxide
= 0.100 × 0.0250
= 0.00250 mol
To know more about titration, visit:
brainly.com/question/27394328
#SPJ9
Answer:
2 CrO42- + 3N2O + 10 H+ -----> 2Cr3+ + 6NO + 5H2O
Explanation:
2 CrO42- + 3N2O + 10 H+ -----> 2Cr3+ + 6NO + 5H2O
Oxidizing agent: -----------------------------> CrO42-
Reducing agent: ----------------------------> N2O
explanation:
in CrO4-2 oxdiation state of Cr = +6
in Cr+3 oxidation state = +3
+6 oxidation state changed from +3 it is reduction .
so CrO4-2 is oxidizing agent
atomatically
N2O should be reducing agent
