Density can be any number, as long as it has the right units.
A unit of density has to be (a unit of mass) divided by (a unit of volume).
The most common one is gram/cm^3.
Answer:
Describing a Force:
To fully describe the force acting upon an object, you must describe both its magnitude and direction. Thus, 10 Newtons of force is not a complete description of the force acting on an object. 10 Newtons, downwards is a complete description of the force acting upon an object.
Explanation:
Answer:
it needs to be shaken but make sure you have enough room to shake it safely
Explanation:
To properly operate the laboratory thermometer it needs to be shaken but make sure you have enough room to shake it safely. This done because there is a small bend in the mercury channel of a clinical thermometer that uses mercury. You must shake the thermometer to get the mercury from a previous reading from the thermometer back into the bulb for taking new reading. The bend prevents flow back into the tube so that one can comfortably take reading.
Answer:
53.64 m/s
Explanation:
Applying,
a = (v-u)/t............. Equation 1
Where a = acceleration of the car, v = final velocity of the car, u = initial velocity of the car, t = time.
make u the subject of the equation
u = v-at............. Equation 2
From the question,
Given: a = -12 mph/s = -5.364 m/s², t = 10 seconds, v = 0 m/s (comes to stop)
Substitute these values into equation 2
u = 0-(-5.364×10)
u = 0+53.64
u = 53.64 m/s
Observe that the object below moves in the negative direction with a changing velocity. An object which moves in the negative direction has a negative velocity. If the object is slowing down then its acceleration vector is directed in the opposite direction as its motion (in this case, a positive acceleration). The dot diagram shows that each consecutive dot is not the same distance apart (i.e., a changing velocity). The position-time graph shows that the slope is changing (meaning a changing velocity) and negative (meaning a negative velocity). The velocity-time graph shows a line with a positive (upward) slope (meaning that there is a positive acceleration); the line is located in the negative region of the graph (corresponding to a negative velocity). The acceleration-time graph shows a horizontal line in the positive region of the graph (meaning a positive acceleration).
I don't know how I can show you the figure
