The horizontal speed has no effect on the answer.
It doesn't matter whether you flick a marble horizontally from the roof,
fire a high-power rifle horizontally from the roof, drive a school bus straight
off the roof, or drop a bowling ball from the roof with zero horizontal speed.
Their vertical speed is completely determined by gravity, (and it happens to
be the same for all of them).
Handy dandy formula for the distance covered by anything that starts out
with zero speed and accelerates to the end:
Distance = (1/2) (acceleration) x (time)²
If the beginning of the journey is on Earth, then the acceleration is
9.8 m/s² ... the acceleration of gravity on Earth. We'll assume that
the 55-meter rooftop in the question is part of a building on Earth.
55 meters = (1/2) (9.8 m/s²) x (time)²
Divide each side
by 4.9 m/s² : 55 m / 4.9 m/s² = (time)²
(time)² = (55/4.9) sec²
Square-root
each side: time = √(55/4.9 sec²)
= 3.35 sec .
Answer:
True
Explanation:
because they can hold marine organism inside
Answer:
Transverse
Explanation:
There are two types of waves, according to the direction of their oscillation:
- Transverse waves: in a transverse wave, the direction of the oscillation is perpendicular to the direction of motion of the wave. Examples of transverse waves are electromagnetic waves
- Longitudinal waves: in a longitudinal wave, the direction of the oscillation is parallel to the direction of motion of the wave. Examples of longitudinal waves are sound waves.
Light waves corresponds to the visible part of the electromagnetic spectrum, which includes all the different types of electromagnetic waves (which consist of oscillations of electric and magnetic fields that are perpendicular to the direction of propagation of the wave): therefore, they are transverse waves.
Answer:
Tension in the chains - In a chain drive, technically, you have a closed-chain (which has no end) going around 2 pulley or gears; looking closely you have 2 parallel chains going in opposite direction. If kept in horizontal direction, the one below the other is the slack side and the other the tight side. The tension on the upper or tight side is more than the slack side. So you need to keep in mind to keep your chain drive tight so that there is no loss or rotation or lags.
Sizes of the pulley/gear - The chain will be warped around a pair of pulley or gear. The sizes of these pulley/gear will also determine the efficiency of the chain drive (consider one big and one small)
Number of pulley/gear - If the number of pulley/gear is more and chain wrapped on it with little complexity will result in decrease in efficiency because of extra tension.
Length of the chain drive - You cannot have much too long chain drive. It will make your slack side more heavy because the end are further away. You have to apply more power and possibilities of lag increases decreasing efficiency. In an ideal situation, this won't happen, but this world isn't ideal.
Friction between chains & pulley/gear - If you have studied gears (involving its teeth), you will come to know that there is friction offered on the two meeting surfaces.
Angle of contact - This would have been explained better with a diagram. Although, if you are familiar with the terms you won't have difficulty understanding. Angle of contact is the angle the chain forms with the pulley/gear at the point of contact with the center of the pulley. The angle of contact should not be too small, or else the things will be slippery.
Explanation:
Then report it and it might be taken down