Answer:
Open
Explanation:
A switch is a part of a circuit where a connection can be made or broken. By convention, when the switch is "open", the connection is broken and current cannot pass. When the switch is "closed", the connection is complete and current can pass.
When chilies burn in our mouths, the surrounding temperature does not affect how hot the taste of the chilli is. It is only the spiciness that we taste in our mouths. This spiciness is caused by the chemical called capsaicin. This chemical is contained in the cells of the chilli. Capsaicin irritates the cells in your mouth so that is why you feel the discomfort in your mouth.
Hope it helps :)
Thank you for posting
your question here at brainly. Feel free to ask more questions.
<span><span>The
best and most correct answer among the choices provided by the question is </span>B.-2.71 V.</span>
Mg2+(aq) + 2e- -> Mg(s) E=-2.37 V
Cu2+(aq) + 2e- -> Cu(s) E =+ 0.34 V
Since Cu is acting as the anode, the equation needs to be
reversed.
Cu(s) -> Cu2+(aq) + 2e- E =- 0.34 V
Ecell= -2.37 V+ (- 0.34 V) = -2.71 V
<span><span>
</span><span>Hope my answer would be a great help for you. </span> </span>
<span> </span>
M=2.45 because you multiply out the equation on the right and divide by 10
The meter out circuit is the flow control circuit design that can most effectively control an overrunning load.
The meter-out circuit can be very accurate, but are not efficient. The meter-out circuit can control overrunning as well as opposing loads while the other one method must be used with opposing loads only. The choice of flown control valve method and the location of the flow control in the circuit are dependent on the type of application being controlled.
<h3>What is a Circuit ?</h3>
In electronics, a circuit is a complete circular conduit through which electricity flows. A simple circuit consists of conductors, a load, and a current source. The term "circuit" broadly refers to any continuous path via which electricity, data, or a signal might flow.
- The directional valve shifts, causing the actuator to move faster than pump flow can fill it due to an overrunning load. Oil is leaking from one side, whereas there is none on the other.
Hence, flow control circuit design that can best control an overrunning load is the opposing circuit
Learn more about Circuit here:
brainly.com/question/26064065
#SPJ4
