Answer:
9
Explanation:
Given parameters:
Concentration of OH⁻ [OH]= 1 x 10⁻⁹M
Solution:
To find the pOH of a solution can be found using the expression below:
pOH = -log₁₀[OH]
[OH] = concentration of the hydroxyl ions
pOH = -log₁₀(1 x 10⁻⁹) = - x -9 = 9
Both the increase in the boling point and the depression on the freezing point are colliative properties.
This is, they are proportional to the number of particles dissolved in the solvent, which is measured by the molality of the solution and the factor i (Van'f Hoff).
The answer to the question is that 1) the boling point of a solution of water and calcium chloride at standard pressure will be higher than the normal boiling point of pure water, and 2) the freezing point of a solution of water and calcium chloride at standard pressure will be lower than the normal freezing point of pure water.
Answer:
Percentage of oxygen = 30%
Percentage of carbon = 30%
Percentage of hydrogen = 40%
Explanation:
Formula:
Percentage of element = given amount / total amount × 100
Given compound:
C₆H₈O₆
Number of atoms of carbon = 6
Number of atoms of hydrogen = 8
Number of atoms of oxygen = 6
Total number of atoms = 20
Percentage of carbon = 6/20 × 100
Percentage of carbon = 30%
Percentage of Hydrogen = 8/20 × 100
Percentage of Hydrogen = 40%
Percentage of oxygen = 6/20 × 100
Percentage of oxygen = 30%
Sucrose; C12H22O11
C9H8O4; acetyl salicylic acid
H2O2; hydrogen peroxide,
NaOH; sodium hydroxideExplanation:
Answer:but-1-ene
Explanation:This is an E2 elimination reaction .
Kindly refer the attachment for complete reaction and products.
Sodium tert-butoxide is a bulky base and hence cannot approach the substrate 2-chlorobutane from the more substituted end and hence major product formed here would not be following zaitsev rule of elimination reaction.
Sodium tert-butoxide would approach from the less hindered side that is through the primary centre and hence would lead to the formation of 1-butene .The major product formed in this reaction would be 1-butene .
As the mechanism of the reaction is E-2 so it will be a concerted mechanism and as sodium tert-butoxide will start abstracting the primary hydrogen through the less hindered side simultaneously chlorine will start leaving. As the steric repulsion in this case is less hence the transition state is relatively stabilised and leads to the formation of a kinetic product 1-butene.
Kinetic product are formed when reactions are dependent upon rate and not on thermodynamical stability.
2-butene is more thermodynamically6 stable as compared to 1-butene
The major product formed does not follow the zaitsev rule of forming a more substituted alkene as sodium tert-butoxide cannot approach to abstract the secondary proton due to steric hindrance.