Power dissipation = (voltage across the component)² / (resistance of the component)
Since the resistance is in the denominator of the fraction in this formula for the
quantity of power dissipated, you can see that when the supply voltage is constant,
the smaller resistance dissipates more power.
So the <u>60w bulb</u> has lower resistance than the 40w bulb.
Answer: Trough
Explanation: The point labeled C in the wave diagram above is the TROUGH of the wave motion. The trough of a wave motion identifies or signifies the point of least or minimum Displacement by measuring the downward Displacement of the wave. The point A is the CREST which is the opposite of the trough, signifying the point of maximum or upward Displacement of the wave cycle.
Point B is the wave amplitude which signifies the maximum extent of vibration from the equilibrium position of a wave. The point labeled D refers to the wavength of the wave motion which is the distance between successive crest or troughs of a wave motion.
Answer:
A. 3,000,000 m
B. 0.25 km
C. 10 m
D. 1,000 cm
Explanation:
no hablo español, así que solo ingrese esto en el traductor de G*ogle
A. One kilometer equals 1000 meters, so
3,000*1,000 = 3,000,000 m
B. One meter equals 0.001 kilometer, so
250*0.001 = 0.25 km
C. One centimeter equals 0.01 meter
1,000*0.01 = 10 m
D. One milimeter equals 0.1 centimer, so
10,000*0.1 = 1,000
1. Millions of gallons of water are wasted by households in America on a yearly basis as a result of wastage of water in the laundry rooms. There are many ways by which water can be conserved in the laundry room, these include:
1. Using a high efficiency washing machine.
2. Choosing the right load sizes and cycles when using washing machines.
3. Wearing clothes more than once before washing them.
4. Collection of grey and rain water.
5. Treat difficult stains before washing them.
2. Using a high efficiency machine will ensure that water is used efficiently. A high efficiency washing machine uses much less water and save about 6,000 gallons of water for an average family on a yearly basis according to Environmental Protection Agency.
Grey water refers to water that have used once. Water that has been used for washing clothes or bathing can be collected again, recycle and use for some household needs such as gardening, flushing of toilet, etc. Water tanks can also be installed to collect rain water which can be used for washing clothes. This will have positive effect on household overall water consumption.
The separation in time between the arrival of primary and secondary wave is called LAG TIME.
The time difference between the arrival of primary wave and secondary wave in a seismogram is called lag time. The primary wave always travels faster than the secondary wave, thus the difference between the two can be obtained by estimating the difference between the arrival time of the two waves/.
