Answer:
Hexane should be used first.
Explanation:
Chromatography is a method of separating the constituents of a mixture by taking advantage of their different rates of movement in a solvent over an adsorbent medium. Chromatography is a means of separation and analysis that utilises fractional separation. It is based on the principle that if a fluid containing a number of substances is allowed to pass though an adsorbent medium, the different substances in the fluid may travel at different rates and be separated.
The rate of movement depends on the relative affinities of the constituents for the solvent and adsorbent medium. i.e solutes which are weakly adsorbed by the adsorbent medium are easily redissolved by the ascending solvent and quickly travel up the adsorbent medium. In addition to that , solutes which are very soluble in the solvent move up at a faster rate than those which are not soluble.
In column Chromatography;
A non-polar solvent should be initiated and applied first. This is because , in a column chromatography, a non-polar compound will be removed at first then later polar compound.
Assuming a polar compound is used first, the polar compounds will be removed alongside with all the non-polar compounds.
From the two Compounds given;
We know that :
Hexane is a non-polar compound and Methylene chloride is a polar compound. As such, Hexane should be used first.
D has the fastest reaction rate because dynamite explodes almost immediately.
A isn't correct because rusting nails take forever to completely rust.
B isn't correct because logs burning can take around 10 to 20 minutes.
C isn't correct because food digestions takes anywhere between 10 minutes to an hour.
this is the answer of your question .
<em>Hope</em><em> </em><em>it</em><em> </em><em>helped </em><em>you</em>
Answer:
STP in chemistry is the abbreviation for Standard Temperature and Pressure. STP most commonly is used when performing calculations on gases, such as gas density. The standard temperature is 273 K (0° Celsius or 32° Fahrenheit) and the standard pressure is 1 atm pressure.
id say physical cause your changing the physical form of the molucles
