Answer:
The science of thermodynamics deals with the fundamental laws that guide how physical processes occur in relation with the energy transfer. When a system or process changes from one state of equilibrium to another, thermodynamics is interested with the amount of heat transfer during the process. On the other hand, the science of heat transfer is simply about the rate of heat and temperature distribution inside a system at a particular point in time.
Explanation:
B) the current will decrease
Answer:
(A) Their high energy
Explanation:
The higher the energy of the x-ray the more "likely" they will pass through.
The x-ray is electromagnetic energy caused by energy changes in an electron.
X-ray are energetic and have enough energy to break up molecules. That is what reveals the bad or damaged cells in our body.
The optimum wavelength is 450 nm because that is the wavelength of maximum absorbance by FeSCN2+(aq)
you should choose a wavelength with maximum absorbance. In this case, you are using the scattered light, not the absorbed light as your signal. So you should avoid wavelengths where there are absorption peaks.
<h3>What is wavelength ?</h3>
A waveform signal that is carried in space or down a wire has a wavelength, which is the separation between two identical places (adjacent crests) in the consecutive cycles. This length is typically defined in wireless systems in metres (m), centimetres (cm), or millimetres (mm) (mm).
- The distance between two waves' crests serves as an illustration of wavelength. When you and another person have the same overall mindset and can easily communicate, that is an example of being on the same wavelength.
Learn more about Wavelength here:
brainly.com/question/10750459
#SPJ4
Answer:
<em>1.228 x </em>
<em> mm </em>
<em></em>
Explanation:
diameter of aluminium bar D = 40 mm
diameter of hole d = 30 mm
compressive Load F = 180 kN = 180 x 
N
modulus of elasticity E = 85 GN/m^2 = 85 x 
Pa
length of bar L = 600 mm
length of hole = 100 mm
true length of bar = 600 - 100 = 500 mm
area of the bar A = 
= 
= 1256.8 mm^2
area of hole a = 
= 
= 549.85 mm^2
Total contraction of the bar = 
total contraction = 
==> 
= <em>1.228 x </em><em> mm </em>
