All categories

3 years ago

In an operating electrical circuit the source of potential difference could be

1 answer:

5 0

In an operating electrical circuit, the source of potential difference is called the energy source, where current flows from the higher potential to the lower potential. The unit of electrical potentials is known as voltage.

<u>Explanation</u>:

As the charging carriers pass through them, the energy is passed to the electrical components inside a circuit. To measure the potential difference we use a voltmeter.
The difference in potential is equal to the sum of current multiplied by the resistance.
The potential difference of one volt is equal to one Joule of energy used by one Charging Coulomb as it flows in a circuit between two points.

You might be interested in

The total energy in a substance as a result of the motion and position of all the particles is _________. a. heat b. temperature

bonufazy [111]

The answer would be Thermal Energy.

3 0

3 years ago

Which of the following describes the principle of conservation of charge?

grigory [225]

Answer: The statement "The charge cannot be created or destroyed describes the principle of the conservation of charge".

Explanation:

According to the conservation of charge, the charge can neither be created nor destroyed. It can be transferred from one system to another.

In an isolated system, the total electric charge remains constant. The net quantity of electric charge is always conserved in the universe.

Therefore, "the charge cannot be created or destroyed" describes the principle of the conservation of charge.

7 0

4 years ago

Pressure, V is volume , T is temperature of a gas and R is gas constant.

Ilya [14]

هاذغهعفذعذهفذهذهغذهفهذهفذهف

6 0

3 years ago

A long, straight, vertical wire carries a current upward. Due east of this wire, in what direction does the magnetic field point

AlexFokin [52]

The magnetic field of the wire will be directed towards west. Using right thumb rule one can get the direction of field lines.

5 0

3 years ago

Given the isotope 2Fes, which has an actual mass of 55.934939 u: a) b) Determine the mass defect of the nucleus in atomic mass u

SSSSS [86.1K]

Answer:

Mass defect of each iron-56 nuclei:

The binding energy per nucleon of Iron-56 is approximately 8.6 MeV.

Explanation:

According to the physics constants table on Chemistry Libretexts:

Proton rest mass: $\rm 1.0072765\;amu$ ;
Neutron rest mass: $\rm 1.0086649\; amu$ .
Speed of light in vacuum: $\rm 2.99792458\times 10^{8}\;m\cdot s^{-1}$ .
Charge on an electron: $\rm 1.6021765\times 10^{-19}\;C$ .

The mass defect of a nucleus is equal to the sum of the mass of its parts (protons and, in most cases, neutrons) minus the mass of the nucleus.

The atomic number of iron is 26. There are 26 protons in each iron-56 nucleus. The mass number 56 indicates that there are 56 nucleons (neutrons and protons) in each iron-56 nucleus. The other $56 - 26 = 30$ particles are neutrons.

The mass of protons and neutrons in each iron-56 nucleus will be:

$\rm 26 \times 1.0072765 + 30 \times 1.0086649 = 56.464736\;amu$ .

According to this question, the mass of an iron-56 nucleus is equal to 55.934939 amu. The mass defect will be

$\rm 56.464736 - 55.934939 = 0.514197\;amu$ .

By the mass-energy equivalence,

$E = m\cdot c^{2}$ .

Refer to this equation, the speed of light in vacuum $c^{2}$ is the conversion factor between mass $m$ and energy $E$ . The value of $c$ is usually given only in SI units $\rm m\cdot s^{-1}$ . Accordingly, the value of $c^{2}$ will be in the SI unit $\rm m^{2}\cdot s^{-2} = J\cdot kg^{-1}$ .

Convert million electron-volts to joules.

One electron-volt is equal to the electrical work done moving an electron across a potential difference of one volt.

$\begin{aligned}\rm 1 MeV&= \rm 10^{6}\; eV\\ &= \rm (10^{6}\times 1.6021765\times 10^{-19}\;C)\times 1\; V\\&=\rm 1.6021765\times 10^{-19}\;J\end{aligned}$ .

Convert the unit of $c^{2}$ from $\rm m^{2}\cdot s^{-2} = J\cdot kg^{-1}$ to the desired $\rm MeV \cdot amu^{-1}$ :

$\begin{aligned}c^{2} &= \rm {\left(2.99792458\times 10^{8}\;m\cdot s^{-1}\right)}^{2}\\&=\rm 8.987551787\times 10^{16}\; m^{2}\cdot s^{-2}\\ &= \rm 8.987551787\times 10^{16}\; J\cdot kg^{-1}\\&= \rm 8.987551787\times 10^{16}\; J\cdot kg^{-1}\times \frac{1\;MeV}{1.6021765\times 10^{-13}\;J}\times \frac{1\times 10^{-3}\;kg}{6.022142\times 10^{23}\;amu}\\&\approx \rm 931.602164\;MeV\cdot amu^{-1}\end{aligned}$ .

Total binding energy in each iron-56 nucleus:

$\begin{aligned}E &= m\cdot c^{2}\\&= \rm 0.514197\;amu \times 9.31602164\;MeV\cdot amu^{-1} \\&=\rm 479.027038\; MeV \end{aligned}$ .

Again, the mass number 56 indicates that there are 56 nucleons in each iron-56 nucleus. The binding energy per nucleon of iron-56 $\mathrm{^{56}Fe}$ will be:

$\displaystyle \rm \frac{479.027038\; MeV}{56} \approx 8.6\; MeV$ .

6 0

3 years ago