There should be a sufficient amount of the selected isotope in the rock.
The half-life of the isotope must be long enough to capture the age of the rock.
Explanation:
Sully must consider two main aspect before selecting her choice isotope for dating.
There must be sufficient amount of the selected isotope in the rock.
The half - life of the isotope must be long enough to capture the age of the rock.
- Radiometric dating gives a rock an absolute numerical age.
- The half-life of an isotope is time take for half of a radioactive element to decay.
- If the half-life of an isotope is very short, all the parent nuclide would have turned to daughter nuclides.
- Also, we must have sufficient amount of both the daughter and parent isotope in the selected rock.
learn more:
Radiometric dating brainly.com/question/7022607
#learnwithBrainly
ANSWER IS (A)
EXPLANATION:
Bronsted-Lowry concept states that a substance is an acid if it can act as a H+ donor.
HCl in aqueous solution means that HCl is present in water, HCl + H2O --> H3O+ + Cl-. This reaction will take place, the H+ from HCl will be donated to H2O. So, HCl is a bronsted-lowry acid by definition.
However, Methanol (CH3OH) its written that it is liquid, i.e. pure methanol, CH3OH(l). It is both acidic as well as basic. when it is mixed with water then it behaves as an acid.
The last one ammonia in gas phase is also neutral because its not in water. if mixed in water it behaves as a base.
The correct answer is B. Low chemical reactivity
Polyethene is a polymer composed of repeating units of the monomer ethene.
The properties of polyethene are as follows:
- density- ranges 0.857 g/cm3 to 0.975 g/cm3.
- specific heat capacity is 1.9 kJ/kg.
- melting temperature is approximately 110 °C.
<h3>What are polymers?</h3>
Polymers are large macromolecules consisting of long repeating chains of smaller molecules known as monomers.
An example of a polymer is polyethene composed of repeating units of the monomer ethene.
The density of polyethylene ranges 0.857 g/cm3 to 0.975 g/cm3.
The specific heat capacity of polyethene is 1.9 kJ/kg.
The melting temperature of polyethene is approximately 110 °C.
Learn more about polyethene at: brainly.com/question/165779
Answer:3 moles
Explanation:
For every three molecules of CO2 that enters the Calvin cycle, one molecule of the three carbon glyceraldehyde 3-phosphate (G3P) is produced. Two molecules of G-3-P are required to produce one molecule of glucose. Therefore, the Calvin cycle needs to make a total of 6 turns to produce two molecules of G-3-P.
