All categories

4 years ago

Air is forced through the water to remove gases is called?

2 answers:

7 0

The process through which air is forced through water to remove gases is called aeration. Aeration is often used as a major step in water treatment plants to remove unwanted gases such as carbon dioxide, odors, and other impurities in water. The process also allows dissolved metals such as iron to oxidize.

iVinArrow [24]4 years ago

3 0

Answer:

d. aeration

Explanation:

You might be interested in

A 1 m long wire of diameter 1mm is submerged in an oil bath of temperature 25-degC. The wire has an electrical resistance per un

Zarrin [17]

Answer:

steady state temperature =88.7deg C

t=time within 1 deg C of it steady state is 8.31s

Explanation:

A 1 m long wire of diameter 1mm is submerged in an oil bath of temperature 25-degC. The wire has an electrical resistance per unit length of 0.01 Ω/m. If a current of 100 A flows through the wire and the convection coefficient is 500W/m2K, what is the steady state temperature of the wire? From the time the current is applied, how long does it take for the wire to reach a temperature within 1-degC of the steady state value? The density of the wire is 8,000kg/m3, its heat capacity is 500 J/kgK and its thermal condu

The diameter of the wire is known to be=1mm

properties=

The density of the wire is 8,000 kg/m3,

heat capacity is 500 J/kgK

themal conductivity is 20W/m.K

electrical resistance per unit length of 0.01 Ω/m

from lump capavity method

$B_{i} =\frac{hr/2}{k}$

500*(2.5*10^-4)/20

0.006<0.1

we know also, to find steady state temperature

$\pi$ Dh(T-Tinf)= $I^{2} R_{e}$

make T the subject of the equation , we have

T=25+ $\frac{100^2*0.01}{\pi*0.001*500 }$

T=88.7 degC

rate of chnage in temperature

dT/dt= $\frac{I^2*Re}{rho*c*\pi*D^2/4 } -\frac{4h}{rho*c*D} (T-Tinf)$

at t=o and integrating both sides $\frac{T-Tinf-(I^2*Re/\pi*Dh) }{Ti-Tinf-(I^2*Re/\pi*Dh } =exp\frac{-4ht}{rho*c*D}$

we have

$\frac{87.7-25-63.7}{25-25-63.7} =exp\frac{4*500t}{8000*500*0.001}$

t=8.31s

steady state temperature =88.7deg C

t=time within 1 degC of it steady stae is 8.31s

7 0

3 years ago

A 10 kg monkey climbs up a massless rope that runs over a frictionless tree limb and back down to a 15 kg package on the ground.

pshichka [43]

Answer:

A. 4,9 m/s2

B. 2,0 m/s2

C. 120 N

Explanation:

In the image, 1 is going to represent the monkey and 2 is going to be the package. Let a_mín be the minimum acceleration that the monkey should have in the upward direction, so the package is barely lifted. Apply Newton’s second law of motion:

$\sum F_y=m_1*a_m_i_n = T-m_1*g$

If the package is barely lifted, that means that T=m_2*g; then:

$\sum F_y =m_1*a_m_i_n=m_2*g-m_1*g$

Solving the equation for a_mín, we have:

$a_m_i_n=((m_2-m_1)/m_1)*g = ((15kg-10kg)/10kg)*9,8 m/s^2 =4,9 m/s^2$

Once the monkey stops its climb and holds onto the rope, we set the equation of Newton’s second law as it follows:

For the monkey: $\sum F_y = m_1*a \rightarrow T-m_1*g=m_1*a$

For the package: $\sum F_y = m_2*a \rightarrow m_2*g - T = m_2*a$

The acceleration a is the same for both monkey and package, but have opposite directions, this means that when the monkey accelerates upwards, the package does it downwards and vice versa. Therefore, the acceleration a on the equation for the package is negative; however, if we invert the signs on the sum of forces, it has the same effect. To be clearer:

For the package: $\sum F_y = -m_2*a \rightarrow T-m2*g=-m_2*a \rightarrow m_2*g -T=m_2 *a$

We have two unknowns and two equations, so we can proceed. We can match both tensions and have:

$m_1*a+m_1*g=m_2*g-m_2*a$

Solving a, we have

$(m_1+m_2)*a =(m_2 - m1)*g\\\\a=((m_2-m_1)/(m_1+m_2))*g \rightarrow a=((15kg-10kg)/(10kg+15kg))*9,8 m/s^2\\\\a= 2,0 m/s^2$

We can then replace this value of a in one for the sums of force and find the tension T:

$T = m_1*a+m_1*g \rightarrow T=m_1*(a+g)\\\\T = 10kg*(2,0 m/s^2+9,8 m/s^2) \\\\T = 120 N$

5 0

4 years ago

Explain how a star's absorption spectrum and the concept of red shift help support the Big Bang Theory.

marta [7]

Answer:

Red shift supports the big bang theory. ... The light from distant galaxies is red shifted (this tells us the galaxies are moving away from us) and the further away the galaxy the greater the red shift (this tells us that the more distant the galaxy the faster it is moving). Constellations look like they are moving because earth is rotating on it's axis.

May I have brainliest, please?

4 0

3 years ago

A wire that is 0.65 m long and carrying a current of 8.2 A is at right angles to a uniform magnetic field. The force on the wire

Luda [366]

Answer:

0.075 T

Explanation:

When a current-carrying wire is immersed in a region with magnetic field, the wire experiences a force, given by

$F=ILB sin \theta$