Answer:
to clear land for agriculture and settlement and to use or sell timber for lumber, paper products, or fuel.
Independent auto lots usually have <u>higher</u> finance rates than dealerships
<u>Explanation:</u>
The finance rates that are charged by the dealers are lower than the finance charges that are charged by the independent auto. In case if you are getting financed through dealerships, you can also negotiate with them to charge finance rates and lower the charges of the finance.
But this negotiation and lowering of the finance rates is not possible with the independent auto lots and thus they charge higher rates compared to the dealerships.
Answer:
square cross section. The bar is made of a 7075-T6 aluminum alloy which has a yield strength of 500 MPa, a tensile strength of 575 MPa, and a fracture toughness of 27.5 MPaâm.
Required:
a. What is the nominal maximum tensile stress on the bar?
b. If there were an initial 1.2 mm deep surface crack on the right surface of the bar, what would the critical stress needed to cause instantaneous fast fracture of the bar be?
Answer:
I think D is correct
Explanation:
C is decreasing function, probably worst
A is arctan -> in radian, the rate of increasing is very slow-> second worst
B(14) = ln(9*14) = 4.8
D(14) = sqrt(8+14^2)=14.2
The answer is D I’m 90% sure
