Answer:
Technician B only
Explanation:
During rotor reconditioning, which is the process also known as machining and sanding, where sanding is the involves the application of between 120 and 150 grit sandpaper while using a non-excessive force that is applied non-directionally for up to 60 seconds on each side such that the surface roughness meets OE standards. The rotors are then cleaned by washing after they are serviced before they can then be installed.
Answer:
hypoeutectoid
Explanation:
ferrite: pure form of iron
cementite: It is iron carbide with 93.3% iron and 6.67% carbon
hypoeutectoid: Eutectoid steel with carbon fraction less than 0.8%
hypereutectoid: Eutectoid Steel with carbon content more than 0.8%
For the mentioned iron-carbide alloy,
% of carbon in iron-carbide alloy= percentage of cementite × percentage of carbon in cementite
% of carbon in iron-carbide alloy= 0.09× 0.0667
= 0.6%
so the alloy is hypoeutectoid
Answer:
Plumbing using a one-way check valve to stop water flowing back on a pump when the pump shuts off.
Explanation:
Diodes are like check valves, keeping current from flowing both ways. Used to create d.c. out of a.c by rectification. Also to block flow if d.c. power like a battery is hooked up in reverse polarity.
[C]
The reason why I say this, is because that is the only option that looks like the "flat shape." Notice that the other options have different designs that wouldn't look the same as the flat shape. The flat shape is just a rectangle you piece of cardboard with smaller rectangles at the end of each side. As you can see, shape C shows both smaller rectangles connected without any other design or cur out.
Hope This Helped! Good Luck!
To solve the problem it is necessary to use the concepts related to frictional dissipation per unit mass, energy balance equation and Volumetric flow rate.
The frictional dissipation per unit mass is defined as
Where,
Superficial velocity of fluid
Fluid viscoisty
Porosity
Fluid density
L = Packed bed length
= Effective particle diameter
Through energy balance equation we have that
Neglect the change in velocity and pressure and the work done we have,
We have also that de grade is defined as
With our values and replacing at the previous equation we have,
Previously with the given depth and height we have to
Therefore the Volumetric flow rate,
Therefore the desired volumetric flow rate is 2456gal/min