It is a field of study that make direct use of phenomena that is "quantum-mechanincal", such as superposition and entanglement. It's used to perform operations on data
Answer: b
Explanation:
When heat is released by the system i.e. system loses heat. So, we take it as negative -Q
When the work is done on the system then it is considered as negative work on the system i.e. -W
In this case, the plunger is pulled out, and work is done on the system. So, we take work as negative work -W
Correct option is b
Answer:
6.05 cm
Explanation:
The given equation is
2 aₓ(x-x₀)=( Vₓ²-V₀ₓ²)
The initial head velocity V₀ₓ =11 m/s
The final head velocity Vₓ is 0
The accelerationis given by =1000 m/s²
the stopping distance = x-x₀=?
So we can wind the stopping distance by following formula
2 (-1000)(x-x₀)=[
]
x-x₀=6.05*
m
=6.05 cm
Answer:
This difference is kept to a minimum because the resistance in transformers is a few tens of ohms and the resistance of modern voltmeters is of the order of MΩ.
Explanation:
A voltmeter is built by a galvanometer and a resistance in series, this set is connected in parallel to the resistance where the voltage is to be measured, therefore the voltage is divided between the voltmeter and the element to be measured, consequently the measured voltage It is less than the calculated one, since for them the resistance of the voltmeter is assumed infinite.
This difference is kept to a minimum because the resistance in transformers is a few tens of ohms and the resistance of modern voltmeters is of the order of MΩ.
