If you don’t transfer enough energy via ___

"A 0.4 kg mass, attached to the end of a 0.75 m string, is whirled around in a circular horizontal path. If the maximum tension

Nimfa-mama [501]

Answer:

The maximum velocity the mass can have if the string is not to break = 29.05 m/s

Explanation:

The force balance in the mass:

The tension in the string must always be equal to the force keeping the mass in horizontal circular motion.

The force keeping the mass in circular motion is given by

F = mv²/r

m = mass of body = 0.4 kg

v = speed of the body in circular motion

r = radius of the circular motion = 0.75 m

Maximum tension the string can withstand will correspond to the maximum velocity of the body in horizontal circular motion

T = F = mv²/r

450 = (0.4)(v²)/(0.75)

v² = 450×0.75/0.4 = 843.75

v = 29.05 m/s

4 0

3 years ago

Read 2 more answers

Gravity is a force between any two objects with mass wht doesn’t a person feel a gravitational force between them herself and an

kipiarov [429]

It is because both of them are attracted towards earth where the heavier body gravity field influence is more in comparision to small. For eg; there are two magnet with less power in besides of huge power or magnetic influence then both of the less power magnet are attracted towards the huge one rather than attracting themselves.

Hope its helps u!

6 0

3 years ago

A rifle is aimed horizontally at a target 50.0 m away. The bullet hits the target 2.90 cm below the aim point. . . Whats the bul

Marina CMI [18]

The problem ask to calculate the bullet's flight time and the bullet's speed as it left the barrel. So base on the problem, the answer would be that the flight time is 0.076 seconds and the speed of the bullet is 657.9 m/s. I hope you are satisfied with my answer and feel free to ask for more if you have questions and further clarifications.

5 0

3 years ago

A mass hanging from a spring is set in motion and its ensuing velocity is given by v (t )equals 2 pi cosine pi t for tgreater th

lianna [129]

Answer:

2(maximum), -2(minimum), -2(maximum).

Explanation:

V(t)= 2πcos πt--------------------------------------------------------------------------------(1).

Therefore, there is a need to integrate v(t) to get S(t).

S(t)= 2×sinπt + C ------------------------------------------------------------------------------(2).

Applying the condition given, we have s(0)= 0.

S(0)= 2sin ×π(0) + C.

Which means that; 0+C= 0. That is; C=0.

S(t)= 2 sin πt.

The mass moves to its highest positions at time,t=half(1/2=.5) and time,t=2.5.

Take note that; sin(π/2) = sin(5π/2) = 1 .

Also, the mass moves to its lowest position at time,t=(3/2); also, sin(3π/2) = -1.

Therefore, we have that 2 maximum; -2 minimum and -2 maximum.

7 0

3 years ago

a tms (transcranial magnetic stimulation) device creates very rapidly changing magnetic fields. the field near a typical pulsed-

Digiron [165]

Part A : 4.33 Volt.

Part B : 4764 Amperes.

Given Data :

Field near a typical pulsed-field machine rises from 0 T to 2.5 T in 200 μs.

Axis of his 2.1-cm-diameter wedding band is parallel to the field.

Part A :

induced emf = rate of change of magnetic flux

= d (B A )/dt

= A dB/dt

= { π (2.1 x 10^-2 / 2)^2) (2.5) } / (200 x 10^-6)

E = 4.33 Volt

Part B :

R = rho L / A

R = { (6.2 x 10^-8) ( π x 0.021) } / (4.5 x 10^-6)

R = 9.10 x 10^-4 Ohm

We know, (I = V/ R)

I = 4.33 Volts / 9.10 x 10^-4 Ohm

I = 4764 Amperes

What exactly is the function of TMS?

Transcranial magnetic stimulation (TMS) is a noninvasive procedure that uses magnetic fields to stimulate nerve cells in the brain to alleviate depression symptoms. TMS is usually used when other depression treatments have failed.

Find more on TMS at : brainly.com/question/13851741

#SPJ4

➤ Although your question isn't complete, I may have assumed that you were referring to this specific question.

The complete question is :

A TMS (transcranial magnetic stimulation) device creates very rapidly changing magnetic fields. The field near a typical pulsed-field machine rises from 0 T to 2.5 T in 200 μs. Suppose a technician holds his hand near the device so that the axis of his 2.1-cm-diameter wedding band is parallel to the field.

Part A: What emf is induced in the ring as the field changes? Express your answer to two significant figure E= ___ unit_

Part B: If the band is made of a gold alloy with resistivity 6.2×10−8Ω⋅m and has a cross-section area 4.5 mm2 , what is the induced current? Express your answer to two significant figures and include the appropriate units. I= ___ units__

6 0

1 year ago

If you don’t transfer enough energy via ____, your cars will crash.