Answer:
Given
acceleration (a) =1.5ms2
Force(F) =2100N
R. t. c mass (m) =?
Form
F=ma(divided by m both sides)
m=F/a
m=2100/105
m=1400kg
mass of car =1400kg
''Energy is destroyed because animals are higher levels do not need as much energy'' is not the valid reason.
<h3>What is respiration?</h3>
Respiration is the cellular process of releasing energy from food. Some of the energy released is used to produce ATP. 90 percent of energy is lost as heat energy whereas 10 percent energy is transferred to other trophic levels.
So we can conclude that ''Energy is destroyed because animals are higher levels do not need as much energy'' is not the valid reason.
Learn more about energy here: brainly.com/question/19666326
<span>sound waves are a type of wave sometimes called compression waves, vibrations with enough of an amplitude can compress and decompress the air adjacent to the object causing the waves to form.</span>
Resistors and reactors, for use over 600 volts, shall not be installed in close enough proximity to combustible materials to constitute a fire hazard and shall have a clearance of not less than<u> 300 mm </u>from combustible materials.
Explanation:
- The hazards associated with high power industrial resistors are primarily due to their open construction, which is necessary for cooling.
- The exposed conductors which make up the resistors can be not only a shock hazard but also a thermal burn hazard.
- When a resistor fails, it either goes open or the resistance increases. When the resistance increases, it can burn the board, or burn itself up.
- Avoid touching non-flammable resistors in operation; the surface temperature ranges from approximately 350 °C to 400°C when utilized at the full rated value. Maintaining a surface temperature of 200°C or less will extend resistors service life.
- Do not apply power to a circuit while measuring resistance. When you are finished using an ohmmeter, switch it to the OFF position if one is provided and remove the leads from the meter.
- Always adjust the ohmmeter for 0 (or in shunt ohmmeter) after you change ranges before making the resistance measurement.
Answer:
true
Explanation:
if they were balance then it would not move
