Which stament best describes resistance

Physics

1 answer:

yaroslaw [1]2 years ago

5 0

Answer:

Resistance is a measure of the opposition to the flow of current in an electrical circuit.

Explanation:

It is symbolized by the Greek letter omega (Ω), resistance is measured in ohms.

If an electric current of one ampere passes through a component across which a potential difference (voltage) of one volt exists, then the resistance of that component is one ohm

You might be interested in

If anyone knows how to do any of these PLEASE help me....im am so confused rn and our teacher sucks at explaining this stuff....

Taya2010 [7]

Take 68.2/60 = 1.137 hr
take 56.9/1.137 = 50.043 mi/hr

take 189/211 = 0.896

24.8/2 = 12.4 m
12.4/82.3 = 0.15s

7 0

2 years ago

Read 2 more answers

The question is on the picture.

Jet001 [13]

Between noon and 2 pm, the amount of water in the rain gauge decreased.
This can be caused by evaporation, which turns water into water vapor.
Precipitation would increase the amount of rain water in the gauges, not decrease it.
Condensation occurs after evaporation but wouldn't decrease the water in the gauges by itself.
Runoff is when water on land drains into water sources such as lakes, rivers, oceans, etc.
So the answer is A. evaporation.

5 0

2 years ago

Read 2 more answers

12) Water flows through a horizontal pipe of cross-sectional area 10.0 cm2 at a pressure of 0.250 atm with a flow rate is 1.00 L

masha68 [24]

Answer:

The pressure after passing the valve is 23,8 [Kpa] ( 0,234 atm) and the pressure drop is about 1,53 [Kpa]

Explanation:

We need to use the formula of bernoulli, in the attached image we can see the fluid throw the pipe, we also can calculate the velocity inside the pipe using the flow rate and the cross sectional area.

For this case, we don't use the elevation difference and therefore those terms can be cancelled.

When the area has reduced the velocity of the fluid is increased but there is a drop pressure through the valve.