The same sample of gas at different temperatures shows that at low
temperatures, most molecules have speeds close to their average
speed.
<h3>
What does the Maxwell-Boltzmann distribution graph show?</h3>
Put simply, a Maxwell-Boltzmann distribution graph shows how the energy of gas particles varies within a system.
This is solely a measurement of the speeds of particles because kinetic energy is directly related to speed.
The Maxwell-Boltzmann distribution in chemistry is the subject of this article.
We will begin by describing how to read a graph of the Maxwell-Boltzmann distribution. This will involve taking a closer look at things like the typical energy and the most likely energy.
The graph will then be changed under various circumstances, such as when a catalyst is added or the temperature is raised.
The Maxwell-Boltzmann distribution, which we previously mentioned, is a probability function that depicts the distribution of energy among the particles of an ideal gas. (For more information on this topic, see Chemical Kinetics.)
To learn more about Maxwell distribution, refer
to brainly.com/question/24419453
#SPJ4
The balanced reaction that describes the reaction of chlorine gas and sodium iodide to produce elemental iodine and sodium chloride in aqueous solution is expressed Cl2+2NaI= I2 + 2NaCl. This kind of reaction is called single replacement reaction where the anion, in this case, is only replaced
Answer: Hello i am confused are you asking a question?
Explanation:
Answer:
8.20 % → Percent yield reaction
Explanation:
To find the percent yield of reaction we apply this:
(Produced yield / Theoretical yield) . 100 = %
Produced yield = 112.9 g
Theoretical yield = 1375.5 g
We replace → (112.9g / 1375.5 g) . 100
8.20 % → Percent yield reaction
Answer:
See explanation
Explanation:
If the spot in TLC is below the solvent front, it will be observed that the spot, instead of being separated by the solvent as expected, will just dissolve away in the solvent and zero actual separation of the mixture is achieved.
If the solute is dissolved away instead of being separated by the solvent, then the experiment fails because no actual separation of the mixture is achieved.
Hence, in TLC, the spot must be applied above the solvent front so that the capillary movement of the solvent through the plate can lead to the eventual separation of the components of the mixture since the various components of the mixture will travel at different speeds through the plate.
Also, if the solvent is above the spot, the solvent may evaporate selectively from the points above the spot while separation is ongoing.