Answer:
The answer is true
Explanation:
Light duty scaffolds are to be used for loads up to 25 lbs./sq. ft.
Answer:
Explanation:
A negative feedback influences the behavior of a system (i.e. a process) in the sense that control elements (controller) reverse the direction of the process by changing input conditions (action component) so that output can be set at a desired condition in order to fulfill safety, quality and cost-worthiness
If your accelerator gets stuck down, do the following:
Shift to neutral.
Apply the brakes.
Keep your eyes on the road and look for a way out.
Warn other drivers by blinking and flashing your hazard lights.
Try to drive the car safely off the road.
Turn off the ignition when you no longer need to change direction.
Answer Explanation:
THERE ARE DIFFERENT PROCESS TECHNIQUES FOR MANUFACTURING PLASTIC BOTTLES:
- EXTRUSION BLOW MOLDING PROCESS: In this process a mold cavity composed of two halves, closes around the parison and pinches off one end. compressed air expands the parison to conform against the cold mold cavity walls
- INJECTION BLOW MOLDING: The process of injection blow modeling is used for the production of hollow plastic bottles
- STRECH BLOW MOLDING: Stretch blow molding uses either the injection or extrusion blow molding process as a basic foundation
Answer:
5 Km
Explanation:
Already, the length of the road is given in the question as 5 km. Therefore, the length will still be the same 5 Km as given.