It depends on "Potential Energy", the amount energy it could have, the amount depending on certain circumstances, like height or force. This was how traditional and some modern rollercoasters work. As the "conveyer belt" pulls you up, the higher you go, the more potential energy you have. Once you are falling down the hill, you are experiencing "Kinetic Energy". Hope it makes sence.
Answer:
Newton's law of cooling states that the rate of heat loss of a body is directly proportional to the difference in the temperatures between the body and its surroundings. The law is frequently qualified to include the condition that the temperature difference is small and the nature of heat transfer mechanism remains the same. As such, it is equivalent to a statement that the heat transfer coefficient, which mediates between heat losses and temperature differences, is a constant. This condition is generally met in heat conduction (where it is guaranteed by Fourier's law) as the thermal conductivity of most materials is only weakly dependent on temperature. In convective heat transfer, Newton's Law is followed for forced air or pumped fluid cooling, where the properties of the fluid do not vary strongly with temperature, but it is only approximately true for buoyancy-driven convection, where the velocity of the flow increases with temperature difference. Finally, in the case of heat transfer by thermal radiation, Newton's law of cooling holds only for very small temperature differences.
When stated in terms of temperature differences, Newton's law (with several further simplifying assumptions, such as a low Biot number and a temperature-independent heat capacity) results in a simple differential equation expressing temperature-difference as a function of time. The solution to that equation describes an exponential decrease of temperature-difference over time. This characteristic decay of the temperature-difference is also associated with Newton's law of cooling
The diameter of venus in km is 12104.507Km.
<h3 /><h3>What is Unit conversion?</h3>
By definition, unit conversion refers to the division or multiplication operation used to convert measurements of the same quantity between various units. The act of converting something from one form to another in mathematics, such as from inches to millimetres or from litres to gallons, is known as conversion.
the diameter of venus = 7,523 miles
1 mile = 1.609 km
so,
diameter of venus = 7523 × 1.609 Km
= 12104.507Km
to learn more about unit conversion go to - brainly.com/question/13016491
#SPJ4
<h3>Reducing Surface Area.</h3>
If the surface area becomes smaller, the pressure becomes larger.
