1answer.
Ask question
Login Signup
Ask question
All categories
  • English
  • Mathematics
  • Social Studies
  • Business
  • History
  • Health
  • Geography
  • Biology
  • Physics
  • Chemistry
  • Computers and Technology
  • Arts
  • World Languages
  • Spanish
  • French
  • German
  • Advanced Placement (AP)
  • SAT
  • Medicine
  • Law
  • Engineering
sergejj [24]
3 years ago
13

. In a water cooling tower air enters at a height of 1 m above the ground level with velocity of 20 m/s and leaves the tower at

a height of 7 m above the ground level with a velocity of 30 m/s. Water enters the tower at a height of 8 m above the ground level with a velocity of 3 m/s and leaves the tower at a height of 0.8 m with a velocity of 1 m/s. Water temperatures at inlet and exit are 800C and 500C respectively, while the inlet and exit temperatures of air are 300C and 700C respectively. The cooling tower is well insulated and a of 2.25 kW drives the air through the cooling tower. Determine the mass flow rate of air required if the mass flow rate of water is 1.5 kg/s.
Engineering
1 answer:
Zinaida [17]3 years ago
4 0

Answer:

w ( mass flow rate of air ) = 3.16 kg/s

Explanation:

<u>Determine the mass flow rate of air </u>

mass flow rate of water = 1.5 kg/s

Height at which air enters the cooling tower = 1m

velocity of air entering at 1 m = 20 m/s

Height at which air leaves the cooling tower = 7 m

attached below is a detailed solution of the problem

You might be interested in
Technician A says that a seal can be pried out of a bore using a sharp chisel. Technician B says that smaller metal-backed seals
attashe74 [19]

Answer:

The correct answer is letter "C": Both.

Explanation:

Industrial seals are used at interfaces between components to prevent leakage, to maintain heat, and to avoid contamination. The design, construction, and materials they use vary depending on industrial use but the most common are Polytetrafluoroethylene (PTFE), Nitrile Buna Rubber (NBR), and fluorocarbon.

Thus, using a sharp chisel could pry a seal out of a hole and a regular socket can often be used to force smaller metal-backed seals into place. Thus, technicians "A" and "B" are correct.

6 0
3 years ago
Read 2 more answers
Legal metrology would protect consumers from businesses that do not take measurements according to defined measuring regulations
sergij07 [2.7K]

From what my research concluded, true

5 0
4 years ago
Determine whether or not each of the following signals is periodic.
Sloan [31]

Answer:

a) periodic (N = 1)

b) not periodic

c) not periodic

d) periodic (N = 8)

e) periodic (N = 16)

Explanation:

For function to be a periodic: f(n) = f(n+N)

a) x[n]=sin(\frac{8\pi}{2}n+1)\\\\sin(\frac{8\pi}{2}n+1)=sin(4\pi n+1)

It is periodic with fundamental period N = 1

b) x[n]=cos(\frac{n}{8} -\pi)\\\\\frac{1}{8} N=2\pi k

N must be integer. So it is nor periodic

c) x[n]=cos(\frac{\pi}{8} n^2)\\\\cos(\frac{\pi}{8} (n+N)^2)=cos(\frac{\pi}{8} (n^2+N^2+2nN)\\\\N^2 = 16 \:\:or\:\:2nN=16

Since N is dependent to n. So it is not periodic.

d) x[n]=cos(\frac{\pi }{2}  n) cos(\frac{\pi }{4}  n)\\\\x[n] = \frac{1}{2} cos(\frac{3\pi }{4} n) + \frac{1}{2} cos(\frac{\pi }{4} n)\\\\N_1=8\:\:and\:\:N_2=8\\

So it is periodic with fundamental period N = 8.

e) x[n]=2cos(\frac{\pi }{4}  n)+sin(\frac{\pi }{8} n)-2cos(\frac{\pi }{2} n+\frac{\pi }{6} )\\\\N_1=8\:\:and\:\:N_2=16\:\:and\:\:N_3=4

So it is periodic with N = 16.

3 0
3 years ago
The percentage modulation of AM changes from 50% to 70%. Originally at 50% modulation, carrier power was 70 W. Now, determine th
adoni [48]

Answer:

What is percentage modulation in AM?

The percent modulation is defined as the ratio of the actual frequency deviation produced by the modulating signal to the maximum allowable frequency deviation.

3 0
2 years ago
What unit of measurment would be used to measure current?
Alex_Xolod [135]

Answer:

The S. I unit of current is Amphere

5 0
4 years ago
Other questions:
  • A 12-kN tensile load will be applied to a 50-m length of steel wire with E = 200 GPa. Determine the smallest diameter wire that
    6·1 answer
  • REM rebound involves the A) tendency for REM sleep periods to become increasingly longer and more frequent as a normal night of
    15·1 answer
  • 1. What is the linear distance traveled in one revolution of a 9 in diameter wheel?
    14·1 answer
  • A program is seeded with 30 faults. During testing, 21 faults are detected, 15 of which are seeded faults and 6 of which are ind
    12·1 answer
  • A workpiece of 2000 mm length and 300 mm width was machined by a planning operation with the feed set at 0.3 mm/stroke. If the m
    11·1 answer
  • Need the answer ASAP
    6·1 answer
  • PLEASE HELP ME RIGHT NOW!!
    11·1 answer
  • What is the answer to life the universe and everything <br> (worth 95 points!)
    13·2 answers
  • The tank shown in the accompanying figure is being filled by pipes 1 and 2. If the water level is to remain constant, what is th
    14·1 answer
  • which of the following is not a general education elective area? group of answer choices humanities/fine arts social/behavioral
    13·1 answer
Add answer
Login
Not registered? Fast signup
Signup
Login Signup
Ask question!