Answer:
4.163 m
Explanation:
Since the length of the bridge is
L = 380 m
And the bridge consists of 2 spans, the initial length of each span is
Due to the increase in temperature, the length of each span increases according to:
where
is the initial length of one span
is the temperature coefficient of thermal expansion
is the increase in temperature
Substituting,
By using Pythagorean's theorem, we can find by how much the height of each span rises due to this thermal expansion (in fact, the new length corresponds to the hypothenuse of a right triangle, in which the base is the original length of the spand, and the rise in heigth is the other side); so we find:
The things that a scientist should consider while observing
the force is the environmental conditions,the force that is expected to act on
the dam, the means to contain that force,
and compare different types of designs in accordance with the location
of the dam
Make the base of the building zero. Then the initial distance is 100m, final distance unknown x. Use gravity, time and initial velocity to solve for final distance.
x - 100 = (0)(5) +(1/2)(-9.81)(5^2)
x - 100 = 0 - 122.625
x = -122.625 + 100
x = -22.625 m below ground
Answer:
Explanation:
Cosmologists refer to a "surface of last scattering" when the CMB photons last hit matter; after that, the universe was too big. So when we map the CMB, we are looking back in time to 380,000 years after the Big Bang, just after the universe was opaque to radiation. But the CMB was first found by accident.
plz mark as brainliest
1. All the relevant resistors are in series, so the total (or equivalent) resistance is the sum of the resistances of the resistors: 20 Ω + 80 Ω + 50 Ω = 150 Ω [choice A].
2. The ammeter will read the current flowing through this circuit. We can find the ammeter reading using Ohm's law in terms of the electromotive force provided by the battery: I = ℰ/R = (30 V)(150 Ω) = 0.20 A [choice C].
3. The voltmeter will measure the potential drop across the 50 Ω resistor, i.e., the voltage at that resistor. We know from question 2 that the current flowing through the resistor is 0.20 A. So, from Ohm's law, V = IR = (0.20 A)(50 Ω) = 10. V, which will be the voltmeter reading [choice F].
4. Trick question? If the circuit becomes open, then no current will flow. Moreover, even if the voltmeter were kept as element of the circuit, voltmeters generally have a very high resistance (an ideal voltmeter has infinite resistance), so the current moving through the circuit will be negligible if not nil. In any case, the ammeter reading would be 0 A [choice B].
