Answer:
1) 0,081 ft/s
2) 0,746 lb/s
Explanation:
The relation between flow and velocity of a fluid is given by:
Q=Av
where:
- Q, flow [ft3/s]
- A, cross section of the pipe [ft2]
- v, velocity of the fluid [ft/s]
1)
To convert our data to appropiate units, we use the following convertion factors:
1 ft=12 inches
1 ft3=7,48 gallons
1 minute=60 seconds
So,
As the pipe has a circular section, we use A=πd^2/4:
Finally:
Q=vA......................v=Q/A
2)
The following formula is used to calculate the specific gravity of a material:
SG = ρ / ρW
where:
- ρ = density of the material [lb/ft3]
- ρW = density of water [lb/ft3] = 62.4 lbs/ft3
then:
ρ = SG*ρW = 1,49* 62,4 lb/ft3 = 93 lb/ft3
To calculate the mass flow, we just use the density of the chloroform in lb/ft3 to relate mass and volume:
Mass number = protons + neutrons
mass number = 5 + 7
mass number = 12
Based on the chemical equation, to balance the equation we use 2 as a coefficients of HCl on left hand side of reaction.
<h3>What is balanced equation?</h3>
Balanced chemical equations are those equation in which each entities are present in same amount on left side as well as on the right side of the chemical reaction.
Given chemical reaction is:
Zn + HCl → ZnCl₂ + H₂
Above reaction is not balanced equation as number of chlorine and hydrogen atoms are not same, so balanced equation will be:
Zn + 2HCl → ZnCl₂ + H₂
Hence we add 2 as a coefficient of HCl to balance the equation.
To know more about balance equation, visit the below link:
brainly.com/question/26694427
Answer:
Standard free-energy change at 
is 
Explanation:
Oxidation: 
Reduction: 
--------------------------------------------------------------------------------------
Overall: 
Standard cell potential, 
So, 
We know, standard free energy change at (
): 
where, n is number of electron exchanged during cell reaction, 1F equal to 96500 C/mol
Here n = 2
So, 
Answer:
It will lead to overestimation of the percent recovery
Explanation:
The percent recovery refers to the percentage of the pure compound recovered after a chemical process. It is a ratio of the pure compound recovered to the original substance multiplied by 100%.
If the sample was incompletely dried and the recrystallization solvent is still present, the percent recovery will be overestimated and we will have a value that is greater than the accurate percent recovery due to solvent impurities present.
