Answer:
I think that it is A I am sorry if I am wrong
Explanation:
<h3>
Answer:</h3>
5.6 Liters
<h3>
Explanation:</h3>
- N.T.P. refers to the standard temperature and pressure (S.T.P).
We need to know that;
- One mole of a gas occupies a volume of 22.4 liters at N.T.P.
In this case;
We have 11 g of CO₂
But, 1 mole of CO₂ occupies 22.4 l at N.T.P.
1 mole of CO₂ = 44 g
Therefore;
44 g of CO₂ = 22.4 liters
What about 11 g ?
= (11 g × 22.4 l)÷ 44 g
= 5.6 l
Therefore, 11 g of CO₂ will occupy a volume of 5.6 liters at N.T.P.
Answer:
it would break when it hits the ground
Explanation:
Answer:
their ability to conduct heat and electricity.
Explanation:
<span>Chemically speaking, rust is a base and any acid will remove it. The choice of acid is going to be the thing to consider, since acid + base = salt and water. Phosphoric acid left a residue because the salt Iron phosphate is insoluble in water. Iron's soluble salts include the chloride, the sulfate and the nitrate. Industrially speaking, you need to "pickle" your iron. Pickling is a process in which dilute sulfuric acid is used to remove any surface corrosion prior to either painting or plating an iron surface. Sulfuric acid is ordinary battery acid and the salt Iron sulfate is not toxic. Sulfuric acid is one of the most common acids used (besides hydrochloric acid). The dilute kind is not terribly corrosive but concentrated sulfuric acid is a thick, syrupy liquid which can cause some nasty chemical burns if allowed to remain on the skin. It also heats up quite a lot when water is added, so this is an "Acid to water not water to acid" situation. The other choice is Hydrochloric acid, known as muriatic acid. The 20% concentrate is available in nearly any hardware store. It isn't as corrosive as concentrated sulfuric acid, but it has a burning, acrid stench, so never use the concentrate without adequate ventilation. It is ordinarily used to remove hard water deposits (boiler scale) but does a good on on rust as well. Concentrated Iron chloride isn't entirely inert but lots of rinsing will turn it back into harmless rust/sludge, especially if the rince water is naturally hard. Nitric acid will remove corrosion from anything, but it is extremely corrosive, smells worse then Hydrochloric acid and isn't easy to get, since it can be used to create some powerful explosives</span>
