Answer:
semiconducting and tellurium
Explanation:
u did the test hope this helps babes
Explanation:
elctronic configuration of manganese
Mn=1s²2s²2p⁶3s²3p⁶4s²3d⁵
ground state
Mn=Ar3d⁵4s²
note that Ar is argon
Answer:
on each side of the salt bridge, which is represented by a double vertical line
Explanation:
While writing a cell notation, the general convention is; anode || cathode. The anode and the cathode are separated by a double line. The anode is written on the lefthand side while the cathode is written on the righthand side.
The cell notation is a shorthand representation of a cell, hence any electrochemical cell can easily be produced based on its cell diagram.
Answer:
63.05% of MgCO3.3H2O by mass
Explanation:
<em>of MgCO3.3H2O in the mixture?</em>
The difference in masses after heating the mixture = Mass of water. With the mass of water we can find its moles and the moles and mass of MgCO3.3H2O to find the mass percent as follows:
<em>Mass water:</em>
3.883g - 2.927g = 0.956g water
<em>Moles water -18.01g/mol-</em>
0.956g water * (1mol/18.01g) = 0.05308 moles H2O.
<em>Moles MgCO3.3H2O:</em>
0.05308 moles H2O * (1mol MgCO3.3H2O / 3mol H2O) =
0.01769 moles MgCO3.3H2O
<em>Mass MgCO3.3H2O -Molar mass: 138.3597g/mol-</em>
0.01769 moles MgCO3.3H2O * (138.3597g/mol) = 2.448g MgCO3.3H2O
<em>Mass percent:</em>
2.448g MgCO3.3H2O / 3.883g Mixture * 100 =
<h3>63.05% of MgCO3.3H2O by mass</h3>
Answer: Rod X.
Explanation:
Ok, the electricity starts in the top left part. First, it must travel in the X rod, then it keeps traveling until it reaches the parallel path, and it can go to the Z rod, to the Y rod, or to both of them, and then it reaches the bulb (the circle with a X inside of it).
We know that two rods are conductors of electricity.
Now, suppose the case where rods Z and Y are the ones that conduct electricity, this means that X does not conduct electricity, then when the current reaches to X it stops (because X does not conduct) then the electricity never reaches the rods Z and Y, and then the electricity never reaches the bulb, but we know that the bulb lights up, so we must have that X is one of the conducting rods.
Then, if for example, Y does not conduct electricity, the electricity still can run through the Z rod and eventually reach the bulb.
So we can conclude that the rod that is definitely a conductor of electricity is rod X