How is thermal energy transferred during conduction?

Physics

1 answer:

Irina-Kira [14]3 years ago

4 0

Answer:

Conduction occurs when a substance is heated, particles will gain more energy, and vibrate more. These molecules then bump into nearby particles and transfer some of their energy to them. This then continues and passes the energy from the hot end down to the colder end of the substance.

Explanation:

May I have brainliest please? :)

You might be interested in

A bowling ball of mass 8 kg hits a wall going 5 m/s and rebounds at a speed of 4 m/s. What was the impulse applied to the bowlin

monitta

Yo, sorry I just resized I am so dumb.

The Answer would be C.

Becuase the wall is pushing off 9 becuase it took 5 and bounced back off 4 so

9 times 8= 72 kg m/s

Sorry about that ):

7 0

3 years ago

Read 2 more answers

During a baseball game, a baseball is struck at ground level by a batter. The ball leaves the baseball bat with an initial speed

krok68 [10]

Answer:

Detailed solution is given below:

3 0

3 years ago

choose a substance you're familiar with. what are its physical and chemical properties? How would you measure its density? What

Artist 52 [7]

You can look at magnesium, it can react with oxygen to form oxides. (chemical) it is malleable and a solid at room temperature. (physical)

to measure its density, the mass and volume can be worked out and from this density too. look up the equation, it is quite easy :)

physical changes -- it can be melted, and oxidized

7 0

4 years ago

Read 2 more answers

What is overproduction

zvonat [6]

Overproduction is the composition of more of materials that can be used or sold.

6 0

3 years ago

Read 2 more answers

Physical data is often used in the court system. In fact, police officers use radar to determine your speed when you are driving

Mashcka [7]

The driver is telling the truth, the radar gun must have been set incorrectly to record relative velocity.

The given parameters:

Speed of the driver observed by the stationary police officer, Vo = 44.7 m/s
Speed of the driver, V = 26.8 m/s.
Speed limit = 60 mph

The speed limit of the driver in meter per second is calculated as follows;

$= 60 \ \times \frac{miles}{hour} \times \frac{1609.34 \ m}{1 \ mile} \times \frac{1 \ hr}{3600 \ s}\\\\= 26.82 \ m/s$

From the speed limit, it is obvious that the driver's speed is within the limit. Thus, we can conclude that the driver is telling the truth, the radar gun must have been set incorrectly to record relative velocity.

Learn more about relative velocity here: brainly.com/question/17228388

6 0

2 years ago