Jerry wants to manufacture flat metal sheets. Which process will he use?

What is the objective of phasing out an INDUCTION MOTOR before putting the machine into commission?

enyata [817]

The main objective of phasing out an INDUCTION MOTOR is to identify the ends of the stator coils.

<h3>What is an induction motor?</h3>

An induction motor is a device based on alternate electricity (AC) which is composed of three different stator coils.

An induction motor is a device also known as an asynchronous motor due to its irregular velocity.

In conclusion, the objective of phasing out an INDUCTION MOTOR is to identify the ends of the stator coils.

Learn more on induction motors here:

brainly.com/question/15721280

#SPJ1

8 0

2 years ago

A hawser is wrapped two full turns around a bollard. By exerting an 80-lb force on the free end of the hawser, a dockworker can

Brut [27]

Answer:

μ=0.329, 2.671 turns.

Explanation:

(a) ln(T2/T1)=μβ β=angle of contact in radians

take T2 as greater tension value and T1 smaller, otherwise the friction would be opposite.

T2=5000 lb and T1=80 lb

we have two full turns which makes total angle of contact=4π radians

μ=ln(T2/T1)/β=(ln(5000/80))/4π

μ=0.329

(b) using the same relation as above we will now compute the angle of contact.

take greater tension as T2 and smaller as T1.

T2=20000 lb T1=80 lb μ=0.329

β=ln(20000/80)/0.329=16.7825 radians

divide the angle of contact by 2π to obtain number of turns.

16.7825/2π =2.671 turns

4 0

3 years ago

How will the delay and active power per device change as you increase the doping density of both the N- and the P-MOSFET?

Murljashka [212]

Answer:

hello your question is incomplete attached below is the missing part of the question

Consider an inverter operating a power supply voltage VDD. Assume that matched condition for this inverter. Make the necessary assumptions to get to an answer for the following questions.

answer : Nd ∝ rt

Explanation:

Determine how the delay and active power per device will change as the doping density of N- and P-MOSFET increases

Pactive ( active power ) = Efs * F

Pactive = $\frac{q^2Nd^2*Xn^2}{6Eo} * f$

also note that ; Pactive ∝ Nd2 (

tD = K . $\frac{Vdd}{(Vdd - Vt )^2}$ since K = constant

Hence : Nd ∝ rt

5 0

3 years ago

Steep safety ramps are built beside mountain highway to enable vehichles with fedective brakes to stop safely. a truck enters a

Veronika [31]

Answer:

a. 6 seconds

b. 180 feet

Explanation:

Images attached to show working.

a. You have the position of the truck so you integrate twice. Use the formula and plug in the time t = 7 sec. Check out uniform acceleration. The time at which the truck's velocity is zero is when it stops.

b. Determine the initial speed. Plug in the time calculated in the previous step. From this we can observe that the truck comes to a stop before the end of the ramp.

7 0

3 years ago

35 points an brainiest if correct

Jet001 [13]

I think the answer is B. 10D

6 0

2 years ago