Answer:
D. 12 cm
Explanation:
A node is a point on a standing wave that does not vibrate.
The nodes of a standing wave are shown in the following sketch.
The red dots are the nodes of the standing wave.
It is observed that the distance between two adjacent nodes is half the wavelength of the wave.
Therefore, if the wavelength of the wave is 24 cm, then the distance from one node to the net must be 24 / 2 = 12 cm.
Hence, choice D is the correct answer.
The answer is C) Surface runoff.
Answer:
a) variation of the energy is equal to the work of the friction force
b) W = Em_{f} -Em₀
, c) he conservation of mechanical energy
Explanation:
a) In an analysis of this problem we can use the energy law, where at the moment the mechanical energy is started it is totally potential, and at the lowest point it is totally kinetic, we can suppose two possibilities, that the friction is zero and therefore by equalizing the energy we set the velocity at the lowest point.
Another case is if the friction is different from zero and in this case the variation of the energy is equal to the work of the friction force, in value it will be lower than in the calculations.
b) the calluses that he would use are to hinder the worker's friction force and energy
W = Em_{f} -Em₀
N d = ½ m v² - m g (y₂-y₁)
y₂-y₁ = 35 -10 = 25m
c) if there is no friction, the physical principle is the conservation of mechanical energy
If there is friction, the principle is that the non-conservative work is equal to the variation of the energy
Answer: In the planet there is life and the star is a store of energy where the planet gets its light, life and energy.
Explanation:
Answer:
B. 6.6%
Explanation:
The percentage error of a measurement can be calculated using the formula;
Percent error = (experimental value - accepted value / accepted value) × 100
In this question, the calibrated 250.0 gram mass is the accepted value while the weighed mass of 266.5 g is the experimental or measured value.
Hence, the percentage error can be calculated thus;
Percent error = (266.5-250.0/250.0) × 100
Percent error = 16.5/250 × 100
Percent error = 0.066 × 100
Percent error = 6.6%