Answer:
Explanation: Mechanical advantage is a measure of the force amplification achieved by using a tool, mechanical device or machine system. The device preserves the input power and simply trades off forces against movement to obtain a desired amplification in the output force.
Answer:
the length of the pipe is 0.85 m or 85 cm
Explanation:
Given the data in the question;
The successive harmonics are; 700 Hz , 900 Hz , and 1100 H
Now, for a closed pipe,
length of pipe (L) = λ/4
Harmonics; 1x, 3x, 5x, 7x, 9x, 11x
1100Hz - 900Hz = 200Hz
⇒ 2x = 200Hz
x = 100Hz ( fundamental frequency )
λ = V/f = 340 /100 = 3.4 m
Now
Length L = λ / 4
L = 3.4 / 4
L = 0.85 m or 85 cm
Therefore, the length of the pipe is 0.85 m or 85 cm
Answer:
<h2>The answer is planetary motion</h2>
Explanation:
According to Johannes Kepler, the laws governing planetary motion
states that:
1. The orbit of a planet is an ellipse with the Sun at one of the two foci.
2. A line segment joining a planet and the Sun sweeps out equal areas
during equal intervals of time.
3. The square of a planet's orbital period is proportional to the cube of the semi-major of its orbit.
Johannes Kepler was a German astronomer, mathematician, and astrologer
Born: 27 December 1571, Weil der Stadt, Germany
Died: 15 November 1630
A. people from the same location share the same personality type.
Answer:
Convergent plate boundary
Explanation:
The convergent plate boundary refers to the type of boundary where two plates move towards each other. Due to this type of motion, there forms a subduction zone, where the denser plate subducts below the lighter plate. This zone of subduction is commonly identified by the presence of a deep and narrow V-shaped depression which is commonly known as the oceanic trench.
When the subducting plate enters into the region of the asthenosphere, the rocks melt and mix with the magma. This magma is then pushed upward due to the force exerted by the convection current that forms in the mantle, and further reaches the over-riding plate and eventually give rise to the formation of volcanoes and volcanic/island arcs.
Thus, this type of plate boundary is responsible for the formation of above-ground volcanic activities.
