Answer:
YES
Explanation:
If we connect batteries in series then the output voltage is the sum of the individual voltage of each battery i.e if you connect three 12 volts batteries in series then their output voltage will be 12+12+12=36 volts, but the current rating of the batteries in series will be same of the individual battery rating in 'mah'.
But when we connect the batteries in parallel their voltage is not added but their current rating in mah is addition of their individual rating.
So, If you want 24 volts from three 12 volts battery then you can connect two of them in series and the other one in parallel with them this will give 24 volts and the current will be addition of the two series batteries and the third which is in parallel with them. You can use this configuration if current value is not a big factor.
Answer:
hello your question lacks the required image attached to this answer is the image required
answer : NOR1(q_) wave is complementary to NOR2(q)
Explanation:
Note ; NOR 2 will be addressed as q in the course of this solution while NOR 1 will be addressed as q_
Initial state is unknown i.e q = 0 and q_= 1
from the diagram the waveform reset and set
= from 0ns to 20ns reset=1 and set=0.from the truth table considering this given condition q=0 and q_bar=1 while
from 30ns to 50ns reset=0 and set=1.from the truth table considering this condition q=1 and q_bar=1.so from 35ns also note there is a delay of 5 ns for the NOR gate hence the NOR 2 will be higher ( 1 )
From 50ns to 65ns both set and reset is 0.so NOR2(q)=0.
From 65 to 75 set=1 and reset=0,so our NOR 2(q)=1 checking from the truth table
also from 75 to 90 set=1 and reset=1 , NOR2(q) is undefined "?" and is mentioned up to 95ns.
since q_ is a complement of q, then NOR1(q_) wave is complementary to NOR2(q)
Answer:
Explanation:
We use kinetic friction when a body is moving i.e.
for calculations.
Static friction is used when a body is in rest while kinetic friction is used when a body is moving and its value is quite low as compared to static friction .
Static friction value increases as we apply more force while kinetic friction occurs when there is relative motion between bodies.
Answer:
D. Perform a thorough visual inspection.