Answer:
to the left
Explanation:
<u>If the concentration of products is increased for a reaction that is in equilibrium, the equilibrium would shift to the left side of the reaction (the reactant's side). </u>
For a reaction that is in equilibrium, the reaction is balanced between the reactants and the products. According to Le Cha telier's principle, if one of the constraints capable of influencing the rate of reactions is applied to such a reaction that is in equilibrium, the equilibrium would shift so as to neutralize the effects created by the constraint.
<em>Hence, in this case, if the concentration of the products of a reaction in equilibrium is increased, the equilibrium would shift in such a way that more reactants are formed so as to annul the effects created by the increase in the concentration of the products. Since reactants are always on the left side of chemical equations, it thus means that the equilibrium would shift to the left.</em>
Answer:
The same number of proteins in their nucleus.
Answer:
A (contains most of the mass of the atom)
Evidence has it that a proton is about 2000 times as massive as an electron.
And there is usually multiple protons and neutrons in the nucleus
From what I just said, you can say that B is wrong
C however is also wrong because protons have a +charge and neutrons are neutrle which means you always have a charge > (greater than) 0
And D is wrong because electrons (which are not in the nucleus) have a neg charge. and protons have a + charge and are in the nucleus
So your answer is A
Hope it helped
Spiky Bob
As the temperature is lowered matter is more likely to exist in the solid state
The answer to the question given above is letter A. Light
Light is considered a load of the parts of a circuit. <span>The load in a circuit can be
any electrical device that converts electrical energy into other usable forms
of energy such as a <span>light bulb.
>></span></span><span>Energy sources include
batteries and generating stations
>>switch-</span><span>is
used in electric circuits to allow the circuit to be turned on and off.</span>
