The examples may be;
making yogurt; If you heat beyond 130F you kill the cultures. The higher the temperature up until that point the faster it cultures until you close in on killer temperature.
Mixing 2 part epoxy; Keep it cool and the reaction time is delayed. On the other hand, heat it up and epoxy reacts quicker. In the winter time and close to 35 Degrees, the reaction time for cement to harden can take 400% more time to set.
The displacement of Edward in the westerly direction is determined as 338.32 km.
<h3>What is displacement of Edward?</h3>
The displacement of Edward can be determined from different methods of vector addition. The method applied here is triangular method.
The angle between the 200 km north west and 150 km west = 60 + 90 = 150⁰
The displacement is the side of the triangle facing 150⁰ = R
R² = a² + b² - 2abcosR
R² = 150² + 200² - (2x 150 x 200)xcos(150)
R² = 62,500 - (-51,961.52)
R² = 114,461.52
R = 338.32 km
Learn more about displacement here: brainly.com/question/321442
#SPJ1
Complete question:
At a particular instant, an electron is located at point (P) in a region of space with a uniform magnetic field that is directed vertically and has a magnitude of 3.47 mT. The electron's velocity at that instant is purely horizontal with a magnitude of 2×10⁵ m/s then how long will it take for the particle to pass through point (P) again? Give your answer in nanoseconds.
[<em>Assume that this experiment takes place in deep space so that the effect of gravity is negligible.</em>]
Answer:
The time it will take the particle to pass through point (P) again is 1.639 ns.
Explanation:
F = qvB
Also;
solving this two equations together;
where;
m is the mass of electron = 9.11 x 10⁻³¹ kg
q is the charge of electron = 1.602 x 10⁻¹⁹ C
B is the strength of the magnetic field = 3.47 x 10⁻³ T
substitute these values and solve for t
Therefore, the time it will take the particle to pass through point (P) again is 1.639 ns.
Answer: A voltmeter must have a high resistance where as an ammeter must have a low resistance.
Explanation:
A voltmeter is a device which is connected in parallel to the component across which voltage needs to be measured. In a parallel circuit voltage drop is same at the nodes. The parallel connection must not offer easier path for current to divert from the main circuit and travel. Thus, a voltmeter must have high resistance.
On the other hand, an ammeter which is used to measure current in the circuit must have low resistance as it is connected in series. It should not offer resistance as it would reduce the actual current and measurement would be inaccurate.
When you shine a lite through a prism is reflects out light through all of the edges and causes light separation. Or just simply shine a laser through the edge of a sideways piece of glass.
I hope that this was helpful for you.
