Main sequence stars fuse hydrogen atoms to form helium atoms in their cores. About 90 percent of the stars in the universe, including the sun, are main sequence stars. These stars can range from about a tenth of the mass of the sun to up to 200 times as massive. Stars start their lives as clouds of dust and gas.
Explanation:
There's a massive amount, just think of anything everyday. Like a table on the floor, or when your walking around and putting pressure on the floor. When you squeeze something which is solid. Anything like that will do.
Answer:
Explanation:
We know,
..............(1)
where,
η = Efficiency of the engine
T₁ = Initial Temperature
T₂ = Final Temperature
Q₁ = Heat available initially
Q₂ = Heat after reaching the temperature T₂
Given:
η =0.280
T₁ = 3.50×10² °C = 350°C = 350+273 = 623K
Q₁ = 3.78 × 10³ J
Substituting the values in the equation (1) we get
or
or
⇒
Now,
The entropy change () is given as:
or
substituting the values in the above equation we get
Here we have to add the two measurements given in the question
The measurement values are given as 1.0090 cm and 0.02 cm.we have to add them on the basis of significant figure rules.
As per the addition rule in terms of significant figures
1-First we have to select the number of significant digits after the decimal point of each quantity.
2-Now we have to remember that during the addition ,the resultant of two quantities will follow the quantity having least number of significant figures after the decimal point.
3-Here we are considering the minimum number of significant figures after the decimal points not the minimum number of significant figures in case of multiplication and division
Now we have to add these two quantities as per the above rule-
1.0090 cm +0.02 cm
=1.0290 cm
Here the result will follow 0.02 which has minimum number of significant figures after the decimal points.
Hence we have to round off the number from 9 of 1.0290
As 9 is greater than 5 ,so he actual result will be 1.03 cm
An unconformity, or abnormality in the layers of rocks, signifies that the process of layering was somehow interrupted. The only feasible choice for this would be (B), where erosion would have interrupted the layering process.