All categories

4 years ago

Explain the difference between planning and shaping by the help of sketch

Engineering

1 answer:

Aleks04 [339]4 years ago

8 0

Explanation:

In shaping work piece will be stationary and tool will reciprocates,but on the other hand in planning work piece will reciprocates and tool will be stationary.Shaping is used for small work piece and planning is used for large work piece.Both shaping and planning are not continuous cutting process,cutting action take place in forward stroke and return stroke is idle stroke.The velocity of return stroke is much more than the forward stroke.

You might be interested in

What is the resultant force on one side of a 25cm diameter circular plate standing at the bottom of 3m of pool water?

Tom [10]

Answer:

F=1.47 KN

Explanation:

Given that

Diameter of plate = 25 cm

Height of pool h = 3 m

We know that force can be given as

F= P x A

P=ρ x g x h

Now by putting the values

P=1000 x 10 x 3

P= 30 KPa

$A=\dfrac{\pi}{4}\times 0.25^2\ m^2$

$A=0.049\ m^2$

F= 30 x 0.049 KN

F=1.47 KN

So the force on the plate will be 1.47 KN.

4 0

3 years ago

Why would the shear stress be considered as the momentum flux.

oksano4ka [1.4K]

Answer:

A fluid flowing along a flat plate will stick to it at the point of contact

Explanation:

and this is known as the no-slip condition. ... This is the precise reason why shear stress in a fluid can also be interpreted as the flux of momentum.

3 0

2 years ago

The melting point of Pb (lead) is 327°C, is the processing at 20°C hot working or cold working?

bonufazy [111]

Answer:

Explained

Explanation:

Cold working: It is plastic deformation of material at temperature below recrystallization temperature. whereas hot working is deforming material above the recrystallization temperature.

Given melting point temp of lead is 327° C and lead recrystallizes at about

0.3 to 0.5 times melting temperature which will be higher that 20°C. Hence we can conclude that at 20°C lead will under go cold working only.

6 0

3 years ago

I. Draw the velocity diagram for the instant shown and determine the velocity of

trapecia [35]

Answer:

?????????????????????????????????????

3 0

3 years ago

Part B Now push the plate down and observe what happens on the shore. Repeat the action three to four more times, and watch the

wolverine [178]

Answer:

A tsunami's trough, the low point beneath the wave's crest, often reaches shore first. When it does, it produces a vacuum effect that sucks coastal water seaward and exposes harbor and sea floors. As the tsunami approaches water is drawn back from the beach to effectively help feed the wave. In a tide the wave is so long that this happens slowly, over a few hours.

Explanation:

4 0

3 years ago