Answer:
d) cut the large sized Cu solid into smaller sized pieces
Explanation:
The aim of the question is to select the right condition for that would increases the rate of the reaction.
a) use a large sized piece of the solid Cu
This option is wrong. Reducing the surface area decreases the reaction rate.
b) lower the initial temperature below 25 °C for the liquid reactant, HNO3
Hugher temperatures leads to faster reactions hence this option is wrong.
c) use a 0.5 M HNO3 instead of 2.0 M HNO3
Higher concentration leads to increased rate of reaction. Hence this option is wrong.
d) cut the large sized Cu solid into smaller sized pieces
This leads to an increased surface area of the reactants, which leads to an increased rate of the reaction. This is the correct option.
Stratovolcanoes, or composite volcanoes, mostly erupt dust, ash, and cinders.
The amount
per 100 g is:
38.7 %
calcium = 38.7g Ca / 100g compound = 38.7g
19.9 %
phosphorus = 19.9g P / 100g compound = 19.9g
41.2 %
oxygen = 41.2g O / 100g compound = 41.2g
The molar amounts of calcium,
phosphorus and oxygen in 100g sample are calculated by dividing each element’s
mass by its molar mass:
Ca = 38.7/40.078
= 0.96
P = 19.9/30.97
= 0.64
O = 41.2/15.99
= 2.57
C0efficients
for the tentative empirical formula are derived by dividing each molar amount
by the lesser value that is 0.64 and in this case, after that multiply wih 2.
Ca = 0.96 /
0.64 = 1.5=1.5 x 2 = 3
P = 0.64 /
0.64 = 1 = 1x2= 2
O = 2.57 /
0.64 = 4= 4x2= 8
Since, the
resulting ratio is calcium 3, phosphorus 2 and oxygen 8
<span>So, the
empirical formula of the compound is Ca</span>₃(PO₄)₂
Answer is: <span>the pH value(level) is the independent variable.</span><span>
</span>
Missing question: <span>We conducted an experiment where we added 0.5 g of lactose to 5 different test tubes all containing 5 different pH levels. What is the independent variable?
In this experiment pH level changes, so results depend on different pH values.
Mass of lactose is same during experiment,so t</span>he number of molecules of product formed per minute is the <span>dependent variable.</span>
When you want to melt an ice, you only need the latent energy of fusion, <span>δhfus. We use the given value, then multiply this with the given amount to determine the amount of energy. Since the energy is per mole basis, use the molar mass of ice which is 18 g/mol. The solution is as follows:
</span>ΔH = 5.96 kJ/mol * 1 mol/18 g * 500 g
<em>ΔH = 165.56 kJ</em><span>
</span>
