.A formula that contains 2 elements is called a.

How do i do this is hard

Zolol [24]

Answer:

I believe it would be E)none of the above.

Explanation:

7 0

3 years ago

The planet Jupiter has an acceleration due to gravity that is approximately 2.4 times as much as the earth (23.2 m s2 ). Which o

kumpel [21]

On Jupiter, C. your weight would increase by a factor of 2.4 . Weight is a product of mass and gravity. Mass does not change dependent upon location.

6 0

4 years ago

Read 2 more answers

Find the intensity of the electromagnetic wave described in each case. (a) an electromagnetic wave with a wavelength of 630 nm a

qaws [65]

Find the intensity of the electromagnetic wave described in each case.

(a) an electromagnetic wave with a wavelength of 645 nm and a peak electric field magnitude of 8.5 V/m.

(b) an electromagnetic wave with an angular frequency of 6.3 ✕ 1018 rad/s and a peak magnetic field magnitude of 10−10 T.

3 0

4 years ago

If the torque required to loosen a nut that holds a wheel on a car has a magnitude of 55 n·m, what force must be exerted at the

erastova [34]

Either 175 N or 157 N depending upon how the value of 48Â° was measured from.
You didn't mention if the angle of 48Â° is from the lug wrench itself, or if it's from the normal to the lug wrench. So I'll solve for both cases and you'll need to select the desired answer.
Since we need a torque of 55 NÂ·m to loosen the nut and our lug wrench is 0.47 m long, that means that we need 55 NÂ·m / 0.47 m = 117 N of usefully applied force in order to loosen the nut. This figure will be used for both possible angles.
Ideally, the force will have a 0Â° degree difference from the normal and 100% of the force will be usefully applied. Any value greater than 0Â° will have the exerted force reduced by the cosine of the angle from the normal. Hence the term "cosine loss".
If the angle of 48Â° is from the normal to the lug wrench, the usefully applied power will be:
U = F*cos(48)
where
U = Useful force
F = Force applied
So solving for F and calculating gives:
U = F*cos(48)
U/cos(48) = F
117 N/0.669130606 = F
174.8537563 N = F
So 175 Newtons of force is required in this situation.
If the 48Â° is from the lug wrench itself, that means that the force is 90Â° - 48Â° = 42Â° from the normal. So doing the calculation again (this time from where we started plugging in values) we get
U/cos(42) = F
117/0.743144825 = F
157.4390294 = F
Or 157 Newtons is required for this case.

6 0

3 years ago

A 300 MHz electromagnetic wave in air (medium 1) is normally incident on the planar boundary of a lossless dielectric medium wit

Masja [62]

Answer:

Wavelength of the incident wave in air = 1 m

Wavelength of the incident wave in medium 2 = 0.33 m

Intrinsic impedance of media 1 = 377 ohms

Intrinsic impedance of media 2 = 125.68 ohms

Check the explanation section for a better understanding

Explanation:

a) Wavelength of the incident wave in air

The frequency of the electromagnetic wave in air, f = 300 MHz = 3 * 10⁸ Hz

Speed of light in air, c = 3 * 10⁸ Hz

Wavelength of the incident wave in air:

$\lambda_{air} = \frac{c}{f} \\\lambda_{air} = \frac{3 * 10^{8} }{3 * 10^{8}} \\\lambda_{air} = 1 m$

Wavelength of the incident wave in medium 2

The refractive index of air in the lossless dielectric medium:

$n = \sqrt{\epsilon_{r} } \\n = \sqrt{9 }\\n =3$

$\lambda_{2} = \frac{c}{nf}\\\lambda_{2} = \frac{3 * 10^{6} }{3 * 3 * 10^{6}}\\\lambda_{2} = 1/3\\\lambda_{2} = 0.33 m$

b) Intrinsic impedances of media 1 and media 2

The intrinsic impedance of media 1 is given as:

$n_1 = \sqrt{\frac{\mu_0}{\epsilon_{0} } }$

Permeability of free space, $\mu_{0} = 4 \pi * 10^{-7} H/m$

Permittivity for air, $\epsilon_{0} = 8.84 * 10^{-12} F/m$

$n_1 = \sqrt{\frac{4\pi * 10^{-7} }{8.84 * 10^{-12} } }$

$n_1 = 377 \Omega$

The intrinsic impedance of media 2 is given as:

$n_2 = \sqrt{\frac{\mu_r \mu_0}{\epsilon_r \epsilon_{0} } }$

Permeability of free space, $\mu_{0} = 4 \pi * 10^{-7} H/m$

Permittivity for air, $\epsilon_{0} = 8.84 * 10^{-12} F/m$

ϵr = 9

$n_2 = \sqrt{\frac{4\pi * 10^{-7} *1 }{8.84 * 10^{-12} *9 } }$

$n_2 = 125.68 \Omega$

c) The reflection coefficient,r and the transmission coefficient,t at the boundary.

Reflection coefficient, $r = \frac{n - n_{0} }{n + n_{0} }$

You didn't put the refractive index at the boundary in the question, you can substitute it into the formula above to find it.

$r = \frac{3 - n_{0} }{3 + n_{0} }$

Transmission coefficient at the boundary, t = r -1

d) The amplitude of the incident electric field is $E_{0} = 10 V/m$

Maximum amplitudes in the total field is given by:

$E = tE_{0}$ and $E = r E_{0}$

E = 10r, E = 10t

3 0

3 years ago