Answer:
Fe(NO3)3 + 3 NaOH ===》Fe(OH)3 + 3 NaNO3
Assuming an ebullioscopic constant of 0.512 °C/m for the water, If you add 30.0g of salt to 3.75kg of water, the boiling-point elevation will be 0.140 °C and the boiling-point of the solution will be 100.14 °C.
<h3>What is the boiling-point elevation?</h3>
Boiling-point elevation describes the phenomenon that the boiling point of a liquid will be higher when another compound is added, meaning that a solution has a higher boiling point than a pure solvent.
- Step 1: Calculate the molality of the solution.
We will use the definition of molality.
b = mass solute / molar mass solute × kg solvent
b = 30.0 g / (58.44 g/mol) × 3.75 kg = 0.137 m
- Step 2: Calculate the boiling-point elevation.
We will use the following expression.
ΔT = Kb × m × i
ΔT = 0.512 °C/m × 0.137 m × 2 = 0.140 °C
where
- ΔT is the boiling-point elevation
- Kb is the ebullioscopic constant.
- b is the molality.
- i is the Van't Hoff factor (i = 2 for NaCl).
The normal boiling-point for water is 100 °C. The boiling-point of the solution will be:
100 °C + 0.140 °C = 100.14 °C
Assuming an ebullioscopic constant of 0.512 °C/m for the water, If you add 30.0g of salt to 3.75kg of water, the boiling-point elevation will be 0.140 °C and the boiling-point of the solution will be 100.14 °C.
Learn more about boiling-point elevation here: brainly.com/question/4206205
10 x 70 = 100 x Part, or
700 = 100 x Part
Now, divide by 100 and get the answer:
Part = 700 / 100 = <span>7</span>
Answer:
Copper ions are reduced into copper atoms.
Cu²⁺₍aq₎ + 2e⁻ → Cu₍s₎
Explanation:
During electrolysis, the positive H⁺ and Cu⁺ ions move to the negative cathode and negative OH⁻ and Cl⁻ ions move to the positive anode.
At cathode, copper ions are preferentially discharged due to the low electromotive force required to discharge them compared to the hydrogen ion. The copper ions gain the two electrons lost by the chloride ions when the are discharged. (2 Cl⁻₍aq₎ → Cl₂₍g₎ + 2e⁻)
Thus the half equation is as follows:
Cu²⁺₍aq₎ + 2e⁻ → Cu₍s₎
Answer:
I would expect to extract the acetic acid.
Explanation:
In the first step, since we are adding a concentrated acid,<u> it will react with the bases present in the mixture (diethylamine and ammonia) </u><u>forming salts</u><u>, </u><u>which are soluble in water</u>. Therefore, after draining the aqueous layer, we will have phenol and acetic acid left in the organic layer.
In the second step, we are adding a diluted base, so it will react with a strong acid. This compound is acetic acid, and its salt will be present in the aqueous layer. Phenol will be left on the organic layer.
