The turbocharger on a car applies a very similar principle to a piston engine. It uses the exhaust gas to drive a turbine. This spins an air compressor that pushes extra air (and oxygen) into the cylinders, allowing them to burn more fuel each second.
it is undesirable that all of the points should fall extremely near, or exactly on, the centerline of the control chart Because:
- It can make it difficult to interpret patterns and draw conclusions in a run chart.
- It can lead hinder the process, and make it unstable.
<h3>When a
data point falls outside the control limits of a run chart ?</h3>
If a data point falls is said to outside the control limits, we can say that the process is said to be out of one's control and it is good that an investigation is done to ascertain and remove the cause or causes.
So, it is undesirable that all of the points should fall extremely near, or exactly on, the centerline of the control chart Because:
- It can make it difficult to interpret patterns and draw conclusions in a run chart.
- It can lead hinder the process, and make it unstable.
Learn more about data point from
brainly.com/question/3514929
#SPJ1
Answer:
See the attached file for the answer.
Explanation:
See the attached file for the explanation
Based on the average velocity at section 2, and the absolute pressures at both sectors, the average speed at section 1 is 2.226 m/s.
<h3>What is the average speed at section 1?</h3>
Density at P₁:
= (40 + 100) / (0.287 x (40 + 273))
= 1.5585 kg/m³
Density at P₂:
= (10 + 100) / (0.287 x (40 + 273))
= 1.2245 kg/m³
The average speed at section 1 is:
= (Density at P₂ x d² x 25.5) / (Density at P₁ x 9d²)
= 2.226 m/s
Find out more on average velocity at brainly.com/question/17444459.
#SPJ1
Answer:
TRUE
Explanation:
Polymers can be natural as well as synthetic
The polymer which are found in nature are called natural polymer tease polymer are not synthesized, they are found in nature
Example of natural polymers is cellulose, proteins etc
On the other hand synthetic polymers are not found in nature they are synthesized in market
There are many example of synthetic polymer
Example : nylon, Teflon etc
So it is a true statement
