All categories

3 years ago

When sedimentary rock sits for years and years will it build up more layers and. Make fossils

1 answer:

6 0

Sedimentary rocks don't necessarily make fossils. Although when animals die on top of the rocks and are never moved, blown away, etc they can get trapped under the growing rock. Which is why fossils are often found in sedimentary rocks.

You might be interested in

When the energy is removed what will happen to a gas?

creativ13 [48]

Answer:

Hey mate 
I hope it helps

Explanation:

<h3>Removing Energy: Removing energy will cause the particles in a liquid to begin locking into place. A. Boiling and Evaporation: Evaporation is the change of a substance from a liquid to a gas. Boiling is the change of a liquid to a vapor, or gas, throughout the liquid.</h3>

<h2>PLZ MARK ME AS BRAIN LIST </h2>

THANKS 

8 0

3 years ago

Read 2 more answers

A scientist formulates the following hypothesis: If plants of the same species

Blababa [14]

Answer:

Growth rate

Explanation:

The responding variable, also known as the DEPENDENT VARIABLE, is the variable that responds to changes or manipulations made to another variable (independent or manipulable variable) in the experiment. It is the measured variable of an experiment.

According to the hypothesis provided for this investigation, the scientist wants to determine if the amount of fertilizer plants of the same species receive will affect their growth rate when planted in the same condition. This shows that the independent variable is the amount of fertilizer to be used while the RESPONDING VARIABLE OR DEPENDENT VARIABLE is the GROWTH RATE OF THE PLANTS because it responds to the amount of fertilizer.

7 0

3 years ago

Assuming that the experiments performed in the absence of inhibitors were conducted by adding 5 μl of a 2 mg/ml enzyme stock sol

prohojiy [21]

Hey there!:

From the given data ;

Reaction volume = 1 mL , enzyme content = 10 ug ( 5 ug in 2 mg/mL )

Enzyme mol Wt = 45,000 , therefore [E]t is 10 ug/mL , this need to be express as "M" So:

[E]t in molar = g/L * mol/g

[E]t = 0.01 g/L * 1 / 45,000

[E]t = 2.22*10⁻⁷

Vmax = 0.758 umole/min/ per mL

= 758 mmole/L/min

=758000 mole/L/min => 758000 M

Therefore :

Kcat = Vmax/ [E]t

Kcat = 758000 / 2.2*10⁻⁷ M

Kcat = 3.41441 *10¹² / min

Kcat = 3.41441*10¹² / 60 per sec

Kcat = 5.7*10¹⁰ s⁻¹

Hence kcat of xyzase is 5.7*10¹⁰ s⁻¹

Hope that helps!

4 0

3 years ago

n the periodic table, the atomic mass of oxygen is listed as 15.9994 amu. Based on this, one can deduce that the most common ___

Anit [1.1K]

Isotope- variation of an element

Sixteen- atomic number of oxygen

4 0

3 years ago

Read 2 more answers

Assuming equal concentrations, arrange these solutions by pH.

LenKa [72]

Answer:

Highest pH(most basic)

Sr(OH)2(aq)

KOH (aq)

NH3(aq)

HF (aq)

HClO4(aq)

Lowest pH(most acidic)

Explanation:

The concentration of H+ ion will determine the pH of a solution. The pH actually reflects the ratio of H+ ion and OH- since both of them can combine into water. Solution with more H+ ion will have a lower pH and called acidic, while more OH- will have high pH and be called basic. Strong acid/base will be ionized more than weak acid/base.

Sr(OH)2(aq) = strong base, release 2 OH- ion per mole

KOH (aq) = Strong base, release 1 OH- per mole

NH3(aq) = weak base, release less than 1 OH- per mole

HF (aq) =strong acid, release 1 H+ per mole

HClO4(aq) = stronger acid, release 1 H+ per mole

8 0

3 years ago