Answer:
on each side of the salt bridge, which is represented by a double vertical line
Explanation:
While writing a cell notation, the general convention is; anode || cathode. The anode and the cathode are separated by a double line. The anode is written on the lefthand side while the cathode is written on the righthand side.
The cell notation is a shorthand representation of a cell, hence any electrochemical cell can easily be produced based on its cell diagram.
Mass of water produced : 0.146 g
<h3>Further explanation</h3>
Given
33.2 mL of 0.245 M lithium hydroxide
Required
mass of water
Solution
Reaction
HNO₃ (aq) + LiOH (aq) → H₂O (l) + LiNO₃ (aq)
mol LiOH :
= M x V
= 0.245 x 33.2 ml
= 8.134 mmol
From the equation, the mol ratio of HNO₃ : H₂O = 1 : 1, so mol H₂O = 8.134 mmol
mass H₂O :
= mol x MW
= 8.134 x 10⁻³ mol x 18 g/mol
= 0.146 g
The answer is b i just took the test
Unfortunately, you failed to include the table 1 from which the molar heat capacity of aluminum could have been obtained. However, as a general rule, the heat needed to raise the temperature of a certain substance by certain degrees is calculated through the equation,
H = mcpdT
where H is heat, m is mass, cp is specific heat capacity, and dT is change in temperature. From a reliable source, cp for aluminum is equal to 0.215 cal/g°C. Substituting this to the equation,
H = (260.5 g)(0.215 cal/g°C)(125°C - 0)
H = 7000.94 cal
